Unicom's broadband is about to expire, and major operators will hold activities at the end of the year
99 yuan pulled a telecom 100 megabyte optical fiber/half a year
10 yuan Unicom 50 trillion/year
(It was originally 100 megabytes, but the maximum access bandwidth of this old cell is only 50 megabytes.)
The initial idea is to set up a double line
The main equipment used is the overturned Feixun K3, and the Lele firmware is brushed,
emmm， OpenWrt, to be exact, don't care about these details!
Unicom is good to say that it used to use direct route dialing
Telecom has some trouble. Shanghai Telecom is now using a new optical cat,
In addition, there is nothing in the setting interface, and basic port forwarding cannot be seen
After consulting the brother who installed broadband, he wanted to know about the super secret of the optical cat,
Result notification
Telecom now has two sets of systems, the old and the new. All configurations of this optical cat are issued from the platform,
If I wanted to change the bridge, I had to contact 10000 people to complain and feed back, so I reported it to them and waited for several days
It's OK today,
Get started
The following configuration information is for reference only
Please modify according to your own network environment
My idea is
The router's native WAN port is connected to the connecting line
Then LAN3 is used as WAN2 and connected to telecom
A new VLAN is added, and the three digit VLAN is added in the figure
Create a new wan interface and select the interface 0.3 (that is, the newly divided vlan)
Firewall area selection wan
(Remember to change the default metric. I wrote it here casually, one is 40, and the other is 41. It seems that there is no problem)
load balancing
Select two wan names for the share name. If you are not clear, you can log in to the router through SSH to view it yourself
cat /etc/config/network
Choose any member name, and select the wan interface shown above
I only keep a balanced policy here
Then add the two members in the above figure
last
Save and Apply! If IPV6 is not connected,
Change the standby member in the last step to use the primary routing table
That's about it,
It's not a big problem,
If there is any problem, please correct it.
