Since the mobile broadband was replaced by the telecom broadband two months ago, I have directly switched the Tianyi Gateway 3.0 to the optical cat mode, that is, the bridge mode. I do not turn on the built-in garbage routing function, because the performance of this gateway is really hot.
The power consumption of the device is 6W, and the power input 12V1A is 12W at most, which means that the power consumption must be greater than 6W when fully turned on. Heat+9 LED lights+2.4G wireless network+optical cat signal conversion.After searching the post bar, it was generally said that it was very hot. How terrible was the fever?Tianyi Gateway 3.0 switches to the lowest power consumption Pure Optical Cat mode, and turns off the routing function and LED lights,Dial from an external Xiaomi router, this gatewayIt's hotter than my 6W electric mosquito repellent liquid heater!It is conservatively estimated that the garbage gateway 3.0 will consume 51.84 kilowatt hours of electricity a year if it is operated all day long at 6W.
The routing function of Tianyi Gateway 3.0 is very weak. When the signal power is set to 100%, it is poor. The stability is extremely poor and packet loss is easy.Those who pursue WiFi quality must connect an external router. By the way, change the gateway to the pure optical cat status, dial and transmit routing signals with the router.
Operation steps
1. Log in to Tianyi Gateway 3.0 super user background:http://192.168.1.1
Super user account: telecomadmin
Super user password: nE7jA% 5m
2. After logging in, click Network, Network Settings, Connection Name 3_INTERNET_B_VID_41
Change the connection mode to bridge (if you cannot select, you can change the encapsulation type and service type, and then call them back to select)
3. IPv6 settings, network, user side management, IPv6 settings
DNSThe source is changed to network connection, as shown in the following figure.
other
Set up dialing on the router
IPv6 test
The factory settings of the gateway have been restored. You need to re register the broadband and gateway.First, call 10000 manual customer service, and the customer service will send you the broadband ID code. Then, in the network, remote management, logical ID authentication, fill in the broadband ID code (generally no password), and register.
Title:[life]Tianyi Gateway 3.0 changed to bridge mode, that is, changed to optical cat mode
Copyright notice:This article uses the "Attribution - Noncommercial Use - Sharing in the Same Way 4.0 International" Creative Sharing Agreement. Please follow the Attribution Agreement for reprinting or use.