stainless steel Technical disclosure of protective fence (word format)
(1) Drill M8 holes on both sides of the center plate and the aluminum alloy base, and fix them with screw rods and screw caps. (2) Draw a straight line parallel to both sides in the length direction from the center on the center plate (bottom iron plate), punch holes (matching screws) on the (center plate) at an interval of 50mm, install screws, and slightly rotate the upper slide bar below until it cannot fall down automatically. (3) Pick up the center plate (with slide bars and small pieces of sectional materials) in a balanced way, and insert the two ends of the slide bars from one side of the aluminum alloy base (large) in turn (note: each slide bar inclines in the same direction). Install the center plate in turn according to the above steps, press in the rubber strips, and adjust the position to ensure that the rubber strips on both sides are parallel on the same working surface. (4) Finally, tighten the screw and fasten the deformation joint device.?