Technical disclosure record of wall, column, roof and beam formwork below 4 ± 0.000
. 1 Material preparation: two and a half layers. 11 thick double-sided film covered bamboo plywood, 50 × 100 battens, wood screws, fastening nuts, seven shaped bolts, split screws, waterproof through wall pull rod bolts, Φ 48 steel pipes, type 3 fasteners, buckles, 10 # channel steel, 8 # channel steel, steel gaskets, customized arc steel back ribs, etc. 1.2 Tool preparation: drilling electric drill, electric saw, axe, wrench, plumb bob, steel tape, guiding rule plate, square ruler, level ruler, supporting line plate, crowbar, etc. 1.3 Operating conditions: 1.3.1 The wall, column and beam reinforcement has been bound, the lower end of the wall and column has been added with formwork support reinforcement, the water and electricity pipelines and embedded parts have been installed, the reinforcement protective layer cushion block has been bound, and the concealed inspection procedures have been completed. 1.3.2 First survey the side column or wall axis of the building, and take this axis as the starting point to lead out each axis, and according to the axis and the construction drawing, snap the internal line and external control line of the template with ink lines. Before construction, the three lines must be in place to facilitate the installation and calibration of the template. After the binding of facade reinforcement is completed, the elevation shall be set out at the upper part of the facade reinforcement on each floor, and the pre inspection procedures shall be completed. 1.3.3 The assembly has been carried out according to the template design drawing, and all fastener connectors shall be fastened. The formwork shall be processed by itself, and the working surface of the processed formwork must be flat and have sufficient strength. The joint of bamboo plywood shall be hard butt joint, and a batten must be added at the joint. The formwork must be stacked with four battens at the bottom, and the stacking height is ≤ 1.5m, which can be used when processing.