A large Convention and Exhibition Center Project construction organization design scheme
(1) An international convention and exhibition center project is located in a city's high-tech development zone, north of Plaza Road and south of Plaza Ring Road. D and E of the project are exhibition halls, of which E is a special exhibition hall. All exhibition halls are equipped with mezzanine on the north side, which is mainly used for office and equipment rooms. The traffic organization, layout management and internal staff entrance of the project will enter the exhibition center from the North South platform. There is a large parking lot on the south side of the basement 1. Vehicles and other vehicles are from the north side of the basement 1. There is a special cargo passage and loading and unloading platform. The entrance for internal staff is from the north and south platform to the exhibition center. There is a large parking lot on the south side of the Basement 1, and vehicles directly enter the exhibition center from the Basement 1. In addition, there are auxiliary entrances on the east and west sides, and circular fire lanes around the building. (2) The project adopts full frame structure, and the floor slab is cast-in-place concrete slab. The wall adopts ceramsite concrete block wall. The foundation is a pile cap structure, and the buried depth of the foundation is 1.2M. (3) The decoration works of this project are granite and glass curtain walls for the exterior wall, mortar and ceramic tile surface course for the interior wall, mixed mortar latex paint surface course, and marble surface course. The floor is marble floor, floor tile floor, cement mortar leveling carpet and other floors. The ceiling is made of light steel keel gypsum board, mixed mortar emulsion paint surface, aluminum alloy square board, etc. (4) Installation works include water supply (aluminum plastic composite pipe), drainage, heating, strong and weak electricity, fire protection, ventilation, air conditioning, elevator, etc.