Populus Euphratica Festival Travel

If the vehicle cannot be started after the battery is discharged (especially the vehicle with automatic transmission), the engine can be started by connecting the battery of another vehicle with a jumper cable.

1. The rated voltage of the batteries of both vehicles must be 12V;

2. The jumper cable must have sufficient current carrying capacity;

3. The jumper cable must be equipped with insulation clamp;

4. The engine of the moped battery must be running.

1. The car stops on a solid, level ground free of oil stain and water, so as not to hinder the driving of other vehicles, but also to ensure personal safety when changing tires;

2. Tighten the hand brake;

3. Put a warning device behind the vehicle and turn on the double bounce light;

4. Use a special wrench to slightly loosen the tire bolt;

5. Place a jack at the jacking points to jack up the vehicle. There are two lifting points on both sides of the vehicle, which are close to the tires. Hands and feet must not be placed under the vehicle to prevent the jack from toppling and the vehicle body from sinking, thus endangering people;

6. Unscrew the bolt of the tire to be replaced, and tighten it with a special wrench after replacing the tire;

7. After landing the wheel, continue to tighten the fixing bolts of the tire with the maximum torque;

8. Put away the replaced tires, tools and jacks.

1. Vehicle overloading, high tire pressure, or damage to the tire itself may cause tire blowout during driving.

2. The rear tire explosion will cause the rear of the car to swing, but the direction will not be out of control. At this time, gently step on the brake repeatedly to stop the vehicle slowly.

3. The front wheel burst will cause the car to run to the side of the broken tire. At this time, the steering wheel should be controlled with both hands, and the accelerator pedal should be released slowly, so that the car can stop by itself using the rotational resistance. Sudden braking and rapid fuel collection will make the vehicle center of gravity move forward, making the vehicle shake off and even enter a spiral state.

When driving on a flat road, if the car brake fails, you should quickly shift from high gear to low gear, and use the traction of the engine to reduce the speed. If braking failure occurs during downhill driving, in addition to engine braking, natural obstacles on the roadside should also be used to stop, so as to minimize the loss of accidents.

1. Side slip is mostly caused by excessive braking before turning, which makes the body load move forward, high speed, late steering and eager to correct the steering direction.

2. If sideslip is caused by excessive braking, release the brake pedal and reverse the direction slightly to restore the traction of the driving wheel; If the side slip is caused by high speed and sudden steering, the accelerator should be released to reduce the speed. At the same time, according to the speed and the state of side slip, gently turn the steering wheel to the side where side slip occurs to change the car from side slip state

If the car suddenly loses control of its direction during driving, it should stop with foot brake decisively, but pay attention not to brake too hard to avoid sideslip.

Ejina is a continental arid climate with a large temperature difference in autumn and winter. You should carry thick coats, long sleeved sweat absorbing clothes, thick trousers, scarves, etc., and wear sunglasses, sun hats, sunscreen, skin moisturizer, lip balm and other items, wet paper towels, personal hygiene products and large capacity portable water bottles.