Foam sponge automatic sinking cutting machine Purpose and characteristics

1. This machine is suitable for cutting sponges, foams and other soft materials

2. Easy to operate and learn, beginners and ordinary workers can operate immediately

3. The cutting surface is not uneven due to the uneven surface of the material

4. Various blades of the whole machine contact the runner to eliminate the noise with wear-resistant rubber, so the noise is low during machine operation.

5. Since this machine uses shock absorber, the durability of the cutting tool is better than that of other manufacturers.

6. When the machine grinds the knife, it is not necessary to remove the knife, and it can be grinded directly on the machine.

　 7. Since the whole working face of the machine can be translated, the working efficiency is improved, and the datum plane is added to standardize the cutting size of materials.

Foam sponge automatic sinking cutting machine Maintenance precautions

Make sure that all the gas pipe joints are not loose, and whether the pipe straps are damaged. If necessary, tighten them. Check whether the clamping block, steel belt and guide wheel are loose and whether the steel belt is tight. Check all buttons and select the function of cutting off, replace the damaged ones, and finally draw a comprehensive inspection graph to check the accuracy of the machine. Check whether all transmission parts are loose, check the meshing of gear and rack, and adjust if necessary. Check whether there is waste at the main air inlet and whether all valves and pressure gauges operate normally. Make sure that the sponge cutting machine is normally protected and there is no problem in the inspection before it can be used normally.

Daily inspection:

1. Check whether there is garbage at the main air inlet of the foam cutter, and whether all valves and pressure gauges work normally.

2. Check whether all gas pipe joints are loose and whether all pipe straps are damaged. Tighten or replace them if necessary.

3. Check whether all transmission parts are loose, check the engagement of gear and rack, and adjust if necessary.

4. Check whether the clamping block, steel belt and guide wheel are loose and whether the steel belt is tight, and adjust if necessary.

5. Loosen the clamping device and push the pulley by hand. It should come and go freely. If there is any abnormality, it should be adjusted or replaced in time.

6. Check whether the connector is loose (refer to relevant electrical instructions for specific operation). Check the performance of all buttons and selector switches, and replace them if damaged.

7. Check whether the strong current cabinet and operating platform are loose, and clean the dust inside the cabinet with a vacuum cleaner or blower.