Construction scheme of outlet pool

[Jiangsu] Construction scheme for wing wall of pump station inlet and outlet pool

Introduction: The forebay, inlet and outlet pools of the main pump house are connected to both banks by wing walls. The wing walls are divided into three types: empty box wall buttress, buttress and suspended wall. The back of the wall is filled with earth, and PS80mm steel plastic flexible permeable pipe drainage system is buried. Yellow sand inverted filter is set around the drainage pipe, and the wing wall is set on the water face D75@3000 Drainage hole...... 4.3 During slope protection construction

Waterproof construction scheme of fire pool

JS cement-based waterproof coating+polyethylene polypropylene fiber, this practice abandons the common practice of SBS high polymer modified asphalt roll, because the fire pool is relatively closed, this process is used instead, which meets both construction requirements and safety requirements.

Analysis on the construction scheme of an industrial pool

The first step is to construct 800m3 foundation cushion of the pool (excavation of foundation pit → bottom cleaning → trench inspection and temporary drainage around → formwork erection → pouring of concrete cushion → layered backfilling and compaction around the cushion), and then construct 300m3 and 50m3 cushion after the completion of backfilling around the cushion. The construction method of cushion is the same as above

Construction Scheme for Industrial Water Pool of a Power Plant

***The reuse pool of the 2 × 300MW engineering water system of the power plant is of reinforced concrete structure. External dimensions: length × width × height=12.8m × 8.8m × 4.45m, and the wall toe around is 400mm thick; There are two partition walls in the middle. The thickness of the partition wall is 300mm. There are five pump foundations and three φ 80 pumps on the top plate (± 0.000m)

Pool anti-corrosion construction scheme document

Water tank anti-corrosion is the most important part of the anti-corrosion project of the project.

Construction scheme of industrial water pool in a factory

Construction Scheme for Industrial Water Pool of a Factory Construction Scheme for Industrial Water Pool of a Factory

Construction scheme of industrial engineering pool

This project is the circulating water pump house and pool project of 4500t/d new dry process cement clinker production line project of a cement company limited in a county.

Full set of construction scheme for industrial water tank

The shape of industrial, fire fighting and domestic water pools is reinforced concrete rectangular pool. The buried depth of the pools is 1.2 meters underground, and the exposed depth is 3.65 meters, 3.15 meters and 3.12 meters respectively. The pool machines are all covered with 500 thick soil. The outer wall of the pool is built with 240 mm thick red brick insulation wall, and the foundation cushion is buried at - 3.0 meters. The bottom plate is poured with C10 concrete whole plate to - 1.2 meters elevation

Model of anti-corrosion construction scheme for pool

Model of anti-corrosion construction scheme for water tank Model of anti-corrosion construction scheme for water tank

Construction scheme of a water purification station pool

**The chemical 400000 t/a * * project is designed by China * * Engineering Company. The water purification station pool includes two clean water pools, two source pools, two suction pools and one domestic clean water pool. The clear water tank and source water tank have clear dimensions of 47000 × 35000 mm in length and width, 6600 mm in height, 3200 mm above the ground, and 40 mm in wall thickness

Detailed Rules for Construction Scheme of a Reservoir

This document is a detailed introduction to the reservoir construction scheme, including construction content, management specifications, etc

Construction scheme of underground fire pool

Construction scheme of underground fire pool, including mechanical excavation of foundation pit, fabrication and installation of foundation formwork, beam formwork construction method, reinforcement engineering construction, etc

Construction scheme document of industrial engineering pool

The double row steel scaffolding is erected along the outside of the pool to pave the springboard and pour concrete, and to stabilize the vertical wall formwork.

Dewatering construction scheme of an accident pool

This project is the accident pool of MCC project. The total earthwork volume is about 20200 m3.

Analysis on construction scheme of reservoir

Purpose: Carefully implement the company's quality policy, carefully organize the construction, ensure that the project is completed with "high quality, fast progress and low cost", adhere to the principle of "safety first, prevention oriented", and create better economic and social benefits. 1.1.2 Content: This plan mainly focuses on the construction procedures, resource allocation of the unit project and the construction party of the main divisional and subdivisional works

Construction plan of a reservoir

The project is located in the north of the first line reservoir. The distance between the adjacent axes is 3.5m. The west side is the main road of the plant area, the east side is the compressed air station, and the north side is the coal and shale raw material area. There is sufficient construction space around.

Construction scheme of fire pool in a park

The Industrial Logistics Park Project of Pross (Chengdu) High tech Zone is located in the West High tech Zone of Chengdu, to the south of Hongguang Road, Hongguang Town, Pixian County, Chengdu, opposite the Chengdu Bonded Logistics Center across Hongguang Road. The construction unit of the project is Pross (Chengdu) High tech Zone Industrial Logistics Park Development Co., Ltd., the design unit is the 11th Design and Research Institute of Information Industry Electronics, and the survey unit is the survey and design unit of China Machinery Engineering Corporation

Construction scheme of special scheme for oil depot pool

This project is Liuyuan oil depot unloading and safety hazard reconstruction project (750m3 oil leakage and accident sewage collection tank, 200m3 sealed oil separation tank project). Reinforced concrete structure, the concrete is poured with C30 anti-seepage concrete, (the bottom of 750m3 oil leakage and accident sewage collection tank is 500mm thick, the wall is 250mm thick, and the bottom of 200m3 sealed oil separation tank is 300mm thick

Construction scheme of water pool for an industrial project in Jiangsu

After entering the site, the appearance of reinforcement shall be checked. The reinforcement shall be straight and free of damage, and the surface shall be free of cracks, oil stains, granular or flaky rust.

Dewatering construction scheme of an accident pool

Dewatering construction scheme of an accident pool Dewatering construction scheme of an accident pool Dewatering construction scheme of an accident pool

Leakage proof construction scheme of a sewage pool

Leakage prevention construction scheme of a sewage pool Leakage prevention construction scheme of a sewage pool Leakage prevention construction scheme of a sewage pool

Construction scheme for cleaning a sewage pool

Sewage tank cleaning construction scheme Sewage tank cleaning construction scheme Sewage tank cleaning construction scheme Sewage tank cleaning construction scheme

Construction scheme of sewage tank of a project

Sewage tank construction scheme of a project Sewage tank construction scheme of a project Sewage tank construction scheme of a project

Construction scheme of fire pool and pump room

The fire pool and pump house of 500kV Zongjiang (East Zong) substation are located in the southwest corner of the station area. The fire pool and pump house are very close, the foundation is almost close together, and the fire pool is in the south of the pump house. The foundation shall be set in the undisturbed solid soil layer, moderately weathered argillaceous silt stratum, and the foundation bearing capacity shall not be less than 180 pka. If it fails to meet the requirements, C20 plain concrete shall be used for replacement.

Construction scheme for clean water reservoir of a water plant

This monomer is part of the water purification plant of ××× Waterworks Phase I Project, located in ×××. Due to the low-lying terrain, the groundwater is very rich. The clear water tank is located in the middle of the water purification plant, which is a single project with the largest floor area in the water purification plant. The tank is basically located below the design ground, and the height of the tank is about 5 meters. The work of the single clear water tank includes: well point dewatering, foundation pit excavation, padding

Construction scheme of fire pool

This document is the construction scheme of a fire pool. The content is detailed and can be used for reference.

Fire pool construction scheme.docx

Method Statement for Precipitation of Accident Pond.doc

Method Statement 11222222222222222222222

！！！！！！！！！！ 111111111111111111111111111111111111111111111111111

Construction scheme for deep foundation pit of clean water reservoir

Construction scheme for deep foundation pit of clean water reservoir, including project overview, foundation pit sloping design, earthwork excavation scheme, foundation pit monitoring, safety protection and emergency measures

Construction scheme of open caisson of fire pool in a mall

The south side of the fire pool of the mall is the mall, and the north side is a six storey residential building 6 meters away from the fire pool. The bottom elevation of the fire pool is 5.6m. In order to ensure the use safety of the residential building during construction, the fire pool adopts the construction method of open caisson. During construction, the open reinforced concrete shaft is first made in the pit, and after it reaches the required strength, it is excavated and transported out in layers in the shaft, so that the shaft is

Construction Scheme for Clean Water Tank of a Steel Plant in Sichuan

The clean loop water tank is located in the air compression workshop of the active center of the power plant in Dahuadi plant area, about 400 meters from the Dahuadi bus station to the site, with convenient transportation. The construction water and electricity shall be connected within 60m from the site. During construction, it is necessary to remove the on-site poles, fences, water tanks, tree transplanting, concrete foundation of water tanks and pipeline relocation.

Sinochem detailed reservoir construction scheme

This project is a 500m3 rectangular reservoir. The pool is 14m long, 10.4m wide and 3.5m high. The covering depth is 1m.

Construction scheme of industrial reservoir structure

The construction coordinates of the industrial reservoir structure are the building coordinates of the power plant, ± 0.00m is equivalent to the 1985 national elevation datum of 570.40m, the elevation is in meters, and other dimensions are in millimeters. The project is located at the east side of the new demineralized water tank and the north side of the comprehensive water pump room. It is arranged in a rectangular double row with six domestic fire and industrial reservoirs, each with a size of 31.225m * 29

Construction scheme document of accident pool pile foundation

The temporary road traffic in the construction site has been basically smooth. The piling area is solid and flat.

Construction scheme of a sewage treatment pool

The project includes three clarifiers with an inner diameter of 23.17m, 1.25m below 0m, 5.85m above 0m, 300-700mm thick bottom and 400mm thick wall.

Construction scheme for pile foundation of an accident pool

The temporary road traffic in the construction site has been basically smooth. The piling area is solid and flat.

Construction Scheme of Industrial Reservoir

This document is the construction scheme of an industrial reservoir. The content includes the construction content and requirements of the industrial reservoir. The content is detailed for reference only.

Construction scheme of fire pool and pump house of a project

The fire pool and pump house of XXXXXX project are located at the Pa-7 to 10 axis of the ramp. The total length of the fire pool is 38.2m and the width is 9m. The bottom plate of the pool is - 3m (local suction pit is - 4m), and the thickness of the bottom plate is h=450/500. The top elevation of the pool wall is+3m, and the total height is 6m. The top of the pool is bricked up to the lane beam or slab bottom. The water pump room is located in Pa-1

Construction scheme of fire pool and concrete retaining wall

1. The - 2F floor of the project is designed as a fire pool, ranging from 2-5 axis to 2-8 axis/2-A-2-D axis, with the bottom plate elevation of -11.76M and the bottom plate elevation of the suction tank of -12.76M; The elevation of top slab is -4.85M. The range of axis 2-5 to axis 2-6 is the pump room, and axis 2-6 to axis 2-8 is the pool. 2. Structural design ① Pool foundation design