12 SPI communication

+Recommended courses Questions/discussions comment Collection

This is an excellent course. You can log in to eeworld to continue watching:
12 SPI communication
Sign in

Course Catalog
Related resources
Course Notes

Course Introduction 14 class hours in total, 5 hours, 51 minutes and 2 seconds

TI Robot System Learning Kit (TI-RSLK) Upgrade

The upgraded TI Robot System Learning Kit (TI-RSLK) is a low-cost robot kit and course teaching aid, which can help students better understand the working principle of electronic system design.

Guess you like it Change

Recommended Posts

How to configure timers in the cc2430 protocol stack?: I want to configure timer 1MS in the protocol stack according to TI's timer bottom driver, and then give a clock to my end node, so that all the end point clocks can synchronize. Now when I configure the timer, I feel confused and don't understand what it means. I hope Great Xia can help me solve my mystery 1. This is the timer I configured. I am not ready to use the callback function, but I am ready to use the interrupt directly. So the 0 I gave is not correct. I want to use the mode mode to generate 1MS clock. I don't know if this can work. After configuration, I didn't understand how to compare it. I saw that there was only one HalT; jsxykj1 Wireless connection

An error occurred in CCSv5: CORTEX_M4_0: Error connecting to the target: The board of the TM4C123GH6PM model I used was compiled without any errors, but an error occurred when burning the simulation: CORTEX_M4_0: Error connecting to the target How can I solve it? Ask God for advice; wuhaorui Microcontroller MCU

Error in input mode of cc3200 GPIO: Use the DO of the photoresistor to output high and low levels, read the level value with the input of GPIO, and control the light on and off. However, the desired phenomenon is still not found. Moreover, Mingming turned off all the lights at the beginning, but it is still on. Here is the code //control the input void ReadDeviceConfiguration() {   & nbsp;  unsigned int uiGPIOPort; ...; Brother Joy19 Wireless connection

Port Driver of 430 MCU: The port of 430 single chip microcomputer is set as output and 3.3V power supply. How much current flows through this port? Has anyone measured it? What is the driving power of 430; zhangdaoyu Microcontroller MCU

Comment area

sii

Where is the TExaS project? I can't find it

20:18:54, July 1, 2023

hawkier

After learning, it's hard, but the video is good

September 3, 2020 18:22:40

Daming 58

TI Robot System Learning Kit (TI-RSLK)

June 22, 2020 13:25:09

hellokt43

TI Robot System Learning Kit (TI-RSLK) Upgrade

13:58:52, May 21, 2020