How to install the wave wheel washing machine installation method of wave wheel washing machine
1. Determine the installation position of the washing machine
It is better not to place the washing machine where the sun shines directly or where the temperature is high. Try to avoid heat sources to prevent deformation of plastic parts and discoloration of paint spraying. It should also be avoided to place it in a damp place to prevent rust or short circuit of wire connector due to long-term moisture. As a result, the washing machine had not been used for several years and had already gone on strike.
2. Different installation requirements for wave wheel washing machine and drum washing machine
The socket and faucet of the drum washing machine are installed on the back, which cannot be seen from the front. Because of the concealed design, they are very beautiful. Therefore, if you plan to buy a drum washing machine, you'd better install a socket and faucet on the back of the washing machine.
The socket and faucet of the wavy wheel washing machine should generally be more than 20 cm higher than the washing machine cover, so that when the washing machine cover is turned over, it is not affected by the socket line and water pipe, or the socket faucet can be installed on the side of the washing machine.
3. There should be floor drain and faucet beside the washing machine
Whether the washing machine is placed on the balcony or in the bathroom, the problem of smooth drainage must be considered first, that is, there must be a floor drain beside the washing machine, so that the washing machine can drain water easily. Otherwise, if there is no drainage facilities, the washing machine can only be moved around each time before washing. This is not what you want. Secondly, consider the water source, That is to say, there should be a faucet beside the washing machine to facilitate water filling during washing.
4. The socket shall not be 0.3m lower than the ground
The reason to pay attention to this point is that the washing machine will splash when draining water. If the socket is too low, the splash will easily fall into the socket, causing short circuit, burning the machine, and sometimes even causing fire. It is suggested that if conditions permit, a waterproof cover can be added on the socket to play a waterproof role.
How to install the washing machine wave wheel
After buying back the washing machine, the package is opened, and then the foam in the box is taken out and cleaned
2: Connect the water inlet pipe to the water inlet valve of the washing machine, connect the water inlet of the water inlet valve to the head end of the water inlet pipe, and tighten the thread
3: Then the water inlet pipe is connected to the faucet. At this time, the connecting pipe and the water inlet pipe should be separated. If the water inlet pipe cannot connect to the faucet, this indicates that the faucet is relatively thick. You can remove the plastic guide sleeve inside the connector