Tulip flower drawing method
(After the fusion is completed, the center selects a point to increase the flow, and stops the injection after the figure appears.
(On the basis of the last point selection, back some injection, slightly increase the flow, and stop injection after the figure appears.
(Repeat the second step for the middle part of the tulip.
(The last figure is the method of pulling the center. When closing, improve it and slowly draw out a straight line.
Method of making ears of wheat
(Make a figure of tulip in the center of the cup. Remember to make it too big. Leave more space on the edge to make ears of wheat.
(Select a point at the end of the tulip, and inject the milk foam (increase the flow, swing and retreat) at the same time.
(Reduce the flow at the end, the smaller the better.
Method of making embossed leaves
(After the fusion, select a point at the center, and inject more flow to swing. When the figure appears, don't worry, and increase the flow in the original place to continue to swing.
(When the first stripe is pressed up, swing the broaching cylinder and continue to increase the flow while retreating.
(The ending also needs to improve the broaching cylinder to reduce the flow.
Dragon's Method
(After fusion, select a point on the side of the cup, inject more liquid and see the liquid start to rotate and flow, and then swing the knurled cylinder.
(At the end, move the broaching jar to pour out the outline of the faucet, and then use the mounting needle to draw the dragon.
Melodic method
(After the fusion is completed, increase the flow near the cup wall and shake it.
(After the rotating state is achieved, move the broaching cylinder to the center of the cup, and increase the flow to swing the broaching center.
Embossing tulip method
(After the fusion, select a point at the center, and inject more flow to swing. When the figure appears, don't worry, and increase the flow in the original place to continue to swing.
(Stop injection when the first fringe is pressed.
(On the basis of the last point selection, back some injection, slightly increase the flow, and stop injection after the figure appears.
(Repeat the second step for the middle part of the tulip.
(The last figure is the method of pulling the center. When closing, improve it and slowly draw out a straight line.