Your current location: home page 》 Product Center 》 Voice IC/module > Flash voice chip > WTN6 (F) series

Product Center Products

Recommended products

WT2605C online AI speech recognition chip

two thousand and twenty-four - 08 - twenty-one

Overview: WT2605C online speech recognition scheme is based on offline speech recognition chip, integrating online speech recognition engine, entry rule engine, NLP natural language processing engine, online TTS engine, streaming media upload, download and play and other technologies. It supports global mainstream language recognition through network connection, and can be widely used in smart homes AI dialogue and prompt broadcast products; The product has low cost

WTK6900HM01 speech recognition control module

two thousand and twenty-three - 09 - twenty-three

Module introduction: WTK6900HM01 is the recognition speech recognition module of the local speech trigger engine, which has the characteristics of low cost, high reliability and strong versatility. In terms of voice technology, it has achieved high reliable wake-up recognition rate, longer distance wake-up, lower false wake-up rate, richer number of voice control commands, stronger anti noise ability, and faster response recognition time. Module features: ● Core and storage - high-performance 32-bit core, 240MHz main frequency, support hardware floating point operation - built-in 1MB SPI FLASH ●&#

WT2605C-32N (A001) seamless circular voice chip ic

two thousand and twenty-three - 09 - fifteen

Product introduction WT2605C is a powerful high-quality voice chip, which uses a high-performance 32-bit processor and can reach a maximum frequency of 240MHz. It has the characteristics of low cost, low power consumption, high reliability, and strong versatility. The existing WT2605C-32N (small size 4 * 4MM) packaging chip. Customize serial communication protocol standard (AT) instructions. SPI Flash, TF card and USB flash drive are supported as memory. It has the functions of file index play, insert, single track cycle, all track cycle, random play, etc. The 31 level volume is adjustable, and the maximum support is

WTR096A-16S recording chip - voice ic

two thousand and twenty-three - 09 - thirteen

Introduction to chip: WTR096A-16S is a powerful high-quality voice chip with a maximum operation speed of 32MHz. It has the characteristics of low cost, low power consumption, high reliability, strong versatility, and can support the storage of 80 seconds of voice content at most with high audio quality (if the customer has no requirements for audio quality, it can store 163 seconds of voice content at most). The chip is equipped with a microphone input interface with automatic gain adjustment, which can support mixing, recording, changing and other effects. Functional features: (1) Working voltage: 2.0V~5.5V, standby current is less than 5uA; (2) 16 bit PWM pure audio input

WTN6 (F) series

WTN6040F-8S voice chip (rewritable ic)

Product features:

(1) Working voltage: 1.8V~5.5V;

(2) Reset condition: low voltage reset (LVR=1.7V) or power-off reset;

(3) 12 bit PWM pure audio output can directly drive 8 Ω/0.5W horn;

(4) It supports 1-wire serial port and 2-wire serial port control (up to 224 voice segments can be loaded, which will be explained later)

(5) Support BUSY status output (the standard program BUSY pin defaults to high level, and low level during voice playback. In addition, in the serial port control mode, the BUSY pin level changes only when the voice chip receives the correct voice address timing);

(6) After the chip plays, and the I/O port (DATA and CLK) keeps the level stable (both high and low levels are available) for 1s, the chip goes into sleep

Scope of application:

Time to market: two thousand and twenty-four - 08 - twenty-six

Product description:

Overview WTN6F series is a low-cost, high-performance CMOS voice chip. The biggest feature is that it can be burned repeatedly. The existing WTN6020-8S-F-B with a voice length of 20s and WTN6040-8S-F-B with a voice length of 40s support the replacement of the downloader, with 100KB voice space. The audio sampling rate is currently up to 32kHz, 16 level volume control, PWM output mode. The chip works in a wide voltage range of 1.8V~5.5V. Function description (1) Working voltage: 1.8V~5.5V; (2) Reset condition: low voltage reset (LVR=1.7V) or power-off reset; (3) 12 bit PWM pure audio output can directly drive 8 Ω/0.5W horn; (4) Support 1-wire serial port and 2-wire serial port control (up to 224 segments of voice can be loaded, which will be explained in detail later) (5) Support BUSY status output (the standard program BUSY pin defaults to high level, and it is low level during voice playback. In addition, in the serial port control mode, the BUSY pin will have level change only when the voice chip receives the correct voice address timing); (6) After the chip is played, and the IO port (DATA and CLK) keeps the level stable (both high and low levels are available) for 1s, the chip enters into sleep mode selection Note: 1. Because WTN6 needs a certain initialization time (about 100MS) to power on, and cannot respond to commands during initialization, it needs to complete initialization to receive control commands normally. 2. Using 4R speakers or parallel speakers may cause the chip PWM to appear LATCH-UP phenomenon, which will result in failure to play. It needs to be powered on again to recover, and the chip may be burned in serious cases. 3. WTN6 chip line serial port control PWM output DEMO board play effect and communication timing demonstration video (click the link to watch): https://v.youku.com/v_show/id_XNDcwMzM4NzI1Ng==.html?spm=a2h0c.8166622.PhoneSokuUgc_1.dtitle Pin description limit parameter Remarks: The sample is tested in the laboratory, and the chip can work normally at - 40 ℃~+85 ℃

Online material download

See more details

product details
Product description
Install Video
Success stories
Related products

summary

WTN6 F series is a low-cost, high-performance CMOS voice chip. The biggest feature is repeatable burning 。 The existing WTN6020-8S-F-B with a voice length of 20s and WTN6040-8S-F-B with a voice length of 40s, WTN6040-8S-F-B supports the replacement of downloader , there is 100KB voice space. The audio sampling rate is currently up to 32kHz, 16 level volume control, PWM output mode. The chip works in a wide voltage range of 1.8V~5.5V.

Function description

(1) Working voltage: 1.8V~5.5V;

(2) Reset condition: low voltage reset (LVR=1.7V) or power-off reset;

(3) 12 bit PWM pure audio output can directly drive 8 Ω/0.5W horn;

(4) It supports 1-wire serial port and 2-wire serial port control (up to 224 voice segments can be loaded, which will be explained later)

(6) After the chip plays, and the I/O port (DATA and CLK) keeps the level stable (both high and low levels are available) for 1s, the chip goes into sleep

Note for model selection:

1. Because the WTN6 needs a certain initialization time (about 100MS) to power on, and cannot respond to commands during initialization, it needs to complete initialization to receive control commands normally.

2. Using 4R speakers or parallel speakers may cause the chip PWM to appear LATCH-UP phenomenon, which will result in failure to play. It needs to be powered on again to recover, and the chip may be burned in serious cases.

3. WTN6 chip line serial port controls PWM output DEMO board playing effect and communication timing Demo video (click the link to watch) :

https://v.youku.com/v_show/id_XNDcwMzM4NzI1Ng==.html?spm=a2h0c.8166622.PhoneSokuUgc_1.dtitle

Pin description

WTN6040F-8S voice chip (rewritable ic)

Limit parameter

WTN6040F-8S voice chip (rewritable ic)

Note: According to the laboratory test results of the sample, the chip can work normally at - 40 ℃~+85 ℃.

DC characteristic

WTN6040F-8S voice chip (rewritable ic)

Typical application field | Product:

Repeatable voice IC

Cooperative customers:

OTP voice chip

Supporting tools:

Repeatable voice IC

Online platform introduction:

Weichuang Zhiyin Online Voice Platform: https://wt588f.waytronic.com:8443

Advantages of Weichuang Zhiyin online voice platform: platform based development process, fast and flexible development method, rich voice resource database, one minute voice editing, one click download and debugging, and accelerating the development progress of engineers' projects.

Product application field:

Repeatable voice IC

WTN6040F-8S voice chip (rewritable ic)

Published: two thousand and twenty-one - 09 - 01

Hot Products / Related products More

WT588SXX-16S Flash voice chip ic

two thousand and twenty-three - 09 - 09

Features of WT588S voice chip products: (1) support multi variety SPI-FLASH (4Mbit-128 Mbit); (2) One line and two line serial communication; (3) Support the upper computer software to make BIN files, and then download them to FLASH; (4) Support WAV audio format; (5) Support 12 bit ADPCM decoding (4K~16Khz); (6) Support PCM decoding, up to 30Khz; (7) PWM output, directly driving 8R 0.5W horn; (8) Chip power supply voltage: 2.4~3.6V, flash power supply voltage range: 2.4V~3.6V; (9) In standby mode, the quiescent current is 5uA (the power consumption is relatively higher if the master control program automatically releases the flash version); (10) A maximum of 1000 voice addresses can be supported; (11) The chip power on initialization time is about 1.5s; (12) After the chip is played, and the I/O port (DATA and CLK) keeps the level stable (both high and low levels are available) for 1s, the chip goes into sleep; ● BIN file compilation of upper computer of WT588S series chips

WT588E02B-8S SOP8 pin voice chip ic

two thousand and twenty-one - 08 - 05

Introduction: WT588E02B-8S is a 16 bit DSP voice chip, internal oscillation 32Mhz, 16 bit PWM decoding newly developed by Shenzhen Weichuang Zhiyin Electronics Co., Ltd. The powerful functions make WT588E02B-8S a leader in the voice chip industry. At present, the WT588E02B-8S can store voice content of 170 seconds at most with high audio quality (if the customer has no requirements for audio quality, it can store voice content of 320 seconds at most). WT588E02B-8S is different from the traditional OTP chip. The biggest breakthrough is that customers can change the internal voice content of the chip online through MCU or supporting downloader; And the chip has built-in hardware SPI, UART, IIC, comparator and other resources, which can customize various personalized functional products for customers. Function description: 1 16 bit DSP voice chip, 32Mhz internal oscillation; 2. Working voltage 2.0~5.5V; 3. 16bit PWM/DAC output can directly drive 8R 0.5W horn; 4. Support WAV files of 6K~32Khz; 5. Customers can

WT588F02B-8S voice chip IC

two thousand and twenty-one - 08 - 05

● Overview WT588F02B-8S is a 16 bit DSP voice chip, internal oscillation 32Mhz, 16 bit PWM decoding newly developed by Shenzhen Weichuang Zhiyin Electronics Co., Ltd. The powerful functions make WT588F02B-8S a leader in the voice chip industry. At present, the WT588F02B-8S can store voice content of 170 seconds at most with high audio quality (if the customer has no requirements for audio quality, it can store voice content of 320 seconds at most). WT588F02B-8S is different from the traditional OTP chip. The biggest breakthrough is that customers can change the internal voice content of the chip online through the matching downloader; And the chip has built-in hardware SPI, UART, IIC, comparator and other resources, which can customize various personalized functional products for customers. ● Function description (1) 16 bit DSP voice chip, 32Mhz internal oscillation; (2) Working voltage 2.2~5.5V; (3) 16bit PWM/DAC output can directly drive 8R 0.5W horn; (4) Support WAV files of 6K~32Khz; (5) Customers can change the internal voice content of the chip through MCU or the supporting downloader; （6...