Product classification (f e n)

All products are classified into (f  n) categories

SZG double cone rotary vacuum dryer

SZG double cone rotary vacuum dryer is a new (x ī n) - generation drying device developed by our factory in the same product technology institute in the United States (gu ó). SZG double cone rotary vacuum dryer has two levels of elastic connection mode of belt and chain, so the equipment runs smoothly. The specially designed tooling fully shows the good concentricity of the two shafts, and the heat medium vacuum system adopts (y òòòěě) rotary joints that can rely on American (gu ó) technology. On this basis, we developed SZG-A, which can both (k ě) stepless speed regulation and (y ò u) constant temperature control. As a (w è i) professional drying equipment manufacturer, we use more than 100 sets of (w ù) to serve (y ò ng) customers every year. Our products range from high temperature heat transfer oil to (w è i) heat medium, medium temperature steam and low temperature hot water - everything. When drying the adhesive (w ù) material, our factory will specially design a "board reading" mechanism or set balls for (w è i) you in the tank.

View Details ➔

CT/CT-C hot air circulation oven

General (y òò ng) type drying equipment is widely applicable to the heating, curing, drying and dehydration of materials and products in pharmaceutical, chemical, food, light industry, heavy industry and other industries. For example: APIs, crude drugs, Chinese herbal pieces, powders, granules, granules, big and small (xi ǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎǎ.

View Details ➔

CT/CT-C hot air circulation oven

Operating principle (l ǐ) The electric (di à n) motor drives the grinding plate to rotate through the reducer, so that the material (w ù) falls from the feed inlet to the middle of the grinding plate through the air lock feeder, and at the same time, the hot air enters the mill from the air inlet. With the rotation of the rotary table, under the action of centrifugal force (y òù ng), the material (w ùù) is carried away towards the edge of the grinding table by the high speed airflow of the wind ring, and the large particles fall directly onto the grinding table to be grinded again (x ī n). When the material (w ù) in the airflow enters the upper part (f ù n) of the separator, under the action of the rotary rotor (y òò ng), the coarse powder falls from the cone bucket to the grinding table to be grinded again (x ī n), and the qualified fine powder is grinded together with the airflow, It is collected by the dust collector, i.e. (w è i) product. The material (w ù) containing (y ǒ u) moisture (f ù n) is dried in the process of contacting with hot gas (t ǐ). By adjusting the temperature of hot air, (n é ng) can meet the requirements of materials with different humidity (w ù) and meet the requirements of all (y ǒ u) moisture (f ù n) of the product. By adjusting the separator, the required thickness of different products can be achieved.

View Details ➔