Usually, the top or bottom of the water pipe is better!

The reserved water inlet for general buildings is located in the kitchen area, and the tap water will be distributed to the toilet, main toilet, guest toilet, balcony and other functional areas through pipes. When the water supply pipe is led from the kitchen, since the reserved water inlet is located at the lower end of the room wall, there is a reserved water inlet from the ground, we usually set a valve at the reserved water inlet, Back end operation of the valve. If we reach the top, we will connect the water pipe from the back of the corresponding valve, open the embedded trunking on the wall from the ground to the top, and install the pipe in the trunking. Contact the top wall from the top, lead it to the toilet area through punching, enter the top of the toilet, set corresponding tee joints from the top, expand the trunking of embedded pipes along the wall, and lead the cold and hot water pipes from top to bottom to the corresponding position. Go down, from the original water supply outlet of the kitchen, it is laid horizontally and vertically along the ground to the corresponding bathroom, laundry room and other areas. Especially after entering the bathroom, due to the different handover status of the north and south toilets, it is generally set in the south where the toilet sinks. In the north, some places directly drain the toilet and floor drain in advance, so some places will not sink, Tiles will be placed below the normal floor. Walking up the wall, there should be a road from the ground to the wall, especially at 90 degrees between the ground and the wall. Tools are often carved into grooves to embed pipes. As long as trunking is made on the wall, the waterproof protective layer made by the original property developer when delivering the house will be damaged accordingly. After corresponding repair, the remaining decoration will be done. If the secondary waterproof is not in place, After a long time, it will still penetrate into the primary waterproof position, which is easy to leak. The construction quality of house decoration is very high.

When walking on the ground, there will inevitably be joints, straight bends, elbows, etc., which are connected by hot-melt welding. When all waterways are completed, we will suppress them. If the pressure is normal after the test, we can proceed to the next process, and we will lay a layer of tiles on the surface. Theoretically, there will be no damage or leakage, but there is a probability problem. However, water leakage is a dew point problem at the welding point of pipe fittings and water pipes, which is very bad. The ceramic tile or wood floor with corresponding dew point and the internal leveling layer will be excavated accordingly. This is a troublesome process of repairing dew point. I suggest that the water pipe should be topped to avoid the above two important hidden dangers in construction. First, it does not need to damage the original waterproof layer. Second, we can keep the corresponding joints at the top. If the same problem occurs at the top, the top is easier to repair, and all the advantages of the top will show up.

The length of the pipeline walking on the top is longer than the pipeline walking on the ground, and the cost will be relatively high. Of course, these are also personal choices. However, as the old saying goes, "two rights harm each other", I prefer to go up. Of course, the most important thing is the owner's choice!