Components of air compressed waste oil-water separator:
1. Coarse grained core cap, coarse grained core, sealing gasket and coarse grained core baseplate;
2. Fine filter chamber and water pipe, transparent plastic pipe, fine filter cover;
3. Three bend cock, stainless steel wire filter screen;
4. Heater and temperature and pressure controller;
5. Manually controlled ejector rod and solenoid valve, etc.
Precautions for selection of air compressed waste oil-water separator:
1. Purchase of products from regular manufacturers: the market price of oil-water separators ranges from hundreds to thousands, and the quality difference is quite large. There are also some fake and inferior products. If you want to buy inferior products cheaply, you may pay for a whole set of fuel injection nozzles, or even change the engine, So when you buy oil-water separator, you must go to the regular maintenance station to buy mainstream products. For the fuel supply of the whole engine system, the model of the added oil-water separator must be larger than the displacement of the original vehicle;
2. Pay attention to timely drainage: don't rest easy when you are installed. There is a transparent plastic water cup under the oil-water separator. When you use the oil-water separator, you must pay attention to timely drainage. If there is too much water, the oil-water separator will not play the role of oil-water separation;
Automatic drainage function; Some foreign manufacturers already have the automatic drainage function. The filter bowl below the oil-water separator is equipped with a water level sensor. When the water level reaches a certain value, the computer display on the dashboard will prompt that there is water, and the oil-water separator will drain. The drainage operation is also very convenient. After parking, pull on the hand brake, turn off the engine, turn the ignition key to the driving position, and press the switch on the dashboard to complete the drainage in about 18 seconds;
3. In the north, the oil-water separator with heating function is selected. In addition, cold weather is also easy to cause damage to the water under the water cup. Especially in the north, many users wear thick cotton padded clothes on the oil-water separator to prevent the oil-water separator from freezing. However, to be on the safe side, it is recommended to use the oil-water separator with electric heating function.
Precautions during operation of air compressed waste oil-water separator:
1. Observe whether the pressure gauge, temperature gauge and other indicating instruments are normal;
2. Adjust the opening of the discharge water pipeline valve to maintain the pressure in the separator to facilitate the discharge of dirty oil in the separator;
3. Observe the working condition of the treated drainage water quality and oil concentration alarm;
4. After discharge, continue to inject clean water for 15 minutes to clean the separator;
5. After stopping the pump, close the inlet and outlet valves to avoid water loss in the cylinder and reduce oxidation and corrosion of the inner wall;
6. The emissions from each use shall be recorded.
The reasonable recycling of waste oil can simplify the processing procedures, but on the contrary, if the waste oil is not collected reasonably, it will bring great difficulties to the processing of waste oil. Like gear oil, it is very difficult to restore the original quality. Because a large amount of waste diesel oil is mixed in the waste oil, and there is no steam equipment, it is difficult for the waste oil recycling station to produce qualified oil, so the following points should be paid attention to when recycling:
The product oil recovered from waste oil can be roughly divided into two categories: mineral oil and animal and vegetable oil. Oil, diesel, gasoline and waste oil recovery companies have different treatment methods.
Waste oil recovery companies deal with mineral oil in two ways. One is diesel, and most of them use poor waste oil as raw material. In fact, waste oil in mineral oil also needs to be classified. Generally speaking, the waste oil will be black after use, that is, diesel, and some are red, that is, gasoline. Hydraulic oil and other oils can be divided into red, yellow and white according to the different colors used, and are generally used to recycle base oil or some low-end products.
Therefore, the treatment of animal and vegetable oils has always been a pain in people's minds. In fact, the treatment of animal and vegetable oils is the same as that of waste oils. The training is biodiesel. The training of animal and vegetable oils is supported by biodiesel, which is tax-free! But there are also some bad businessmen who process the waste oil with this sense of smell and then sell it to consumers as good edible oil again. As a waste oil recovery company, we strongly oppose this behavior and condemn it!
Waste oil recovery refers to the process of recycling waste lubricating oil, fuel oil, engine oil and other oil products. Waste oil recovery can reduce the pollution of waste oil products to the environment, and can also save energy resources. The technologies of waste oil recovery mainly include physical methods, chemical methods and biotechnology. The process of waste oil recovery needs to be strictly supervised and managed to ensure that the recovered oil products comply with relevant standards and regulations. At the same time, attention should be paid to safety issues to avoid accidents such as fire and explosion.
Waste oil recovery refers to the recycling of waste edible oil or industrial oil. Waste edible oil can be processed and reused for food processing and biodiesel production; Waste industrial oil can be processed and reused for industrial production and power generation. Waste oil recovery can reduce the generation of waste, reduce environmental pollution, and also have economic benefits.
The deterioration of lubricating oil is generally caused by the deterioration of 1%~10% of the hydrocarbons, and most of the remaining hydrocarbon components are still the main viscosity carriers and effective components of lubricating oil, which is the potential value of waste engine oil, tire oil, crude oil, waste diesel oil regeneration, waste lubricating oil regeneration and refining, and waste oil coal refining.
There are organic compounds and chemical additives containing oxygen, nitrogen and sulfur in waste lubricating oil. If these waste oils are discarded or burned, they will not only cause a great waste of energy, but also cause serious environmental pollution. Therefore, the recycling of waste oil can not only save energy and turn waste into treasure, but also reduce its environmental pollution. The recycling of waste oil has its social significance.
