Strong strength type of MCS Tile adhesive Product features:
Strong adhesion, suitable for all kinds of ceramic tiles Slate Paste the base surface; During construction, it is not necessary to soak bricks to wet the wall, which can significantly improve the work efficiency, and is convenient and fast; Time saving, material saving, and tradition cement The paste pasting method is safer and more secure than the paste pasting method; It has good bonding strength and aging resistance. The thin layer full paste paste method with tooth scraper is not easy to empty, and the construction efficiency can be more than 2 times higher than the traditional paste method.
Base treatment:
The base surface must be firm, flat, clean, free of dust, oil and sundries. Empty and loose parts shall be removed and cement shall be used mortar Repair and chisel.
Construction process:
First pour the water into the mixing bucket, slowly add the powder while stirring with the electric mixer, fully mix until there is no granule paste, and then let it stand for a few minutes and mix slightly before use. Mixing ratio: powder: water=20 ∶ (4.5~5.5), use a tooth scraper to evenly mix the mortar on the base surface, scrape about 1 ㎡ each time, and then board Smoothly knead and press on the base surface. If it is used for tiles or stones with deep back ditch, the tooth scraper shall be used to apply mortar on the back of the tiles to ensure no hollowing. After paving and pasting for 24 hours, you can step in or fill the joint. It is recommended to use Mikass color Jieli impermeable joint sealant for better joint filling effect.
matters needing attention: It is not allowed to construct below 5 ℃ or in the rain. If the foundation surface is too dry or absorbs water too quickly before construction, the foundation surface shall be wetted in advance until there is no open water; Do not mix the dried glue with water for reuse; The residual mortar on the brick surface shall be cleaned with a slightly wet sponge in time; If it is necessary to paste ceramic tiles on a smooth base surface, it is recommended to use Markus interfacial agent to roughen and then paste ceramic tiles to avoid hollowing or falling off.
consumption:
Use 3 × 3mm tooth scraper, the dosage is about 1.8kg/m2; The amount of 6 × 6mm tooth scraper is about 3.5kg/m2; Use a 10 × 10mm tooth scraper, and the dosage is about 5kg/㎡.
Storage method:
This product should be kept in a cool and dry place, and can be stored for one year if not opened.
Executive standard: GB/T25181-2010
Product packaging: 20kg/bag
