★ Product features:
*Quick Clear electric machinery Electrical cabinet And other equipment On Oil dirt, dust, moisture, salt and other dirt, Failure prevention happen.
* Insulation voltage the height is 25KV , Direct Electrification Clean the motor Electrical cabinet And other electrical equipment , Convenient operation and high working efficiency.
*Not easy to burn, For most metals coating The finish, insulation coating, oil resistant rubber and plastic are all safe and harmless.
*Pure quality, complete volatilization, free of harmful HCFCs, Safe and reliable, capable of greatly Extend the service life of equipment ,
★ Physical characteristics:
Appearance: colorless transparent liquid Specific gravity: 0.75 ± 0.02 PH value: 7
Distillation range: 150-190℃ Flash point: 60℃ Withstand voltage ≥25KV
Refractive index: ND1.405 Foam test: no foam Non volatile matter: less than 0.02%
Chloride: less than 0.01% Fluoride: 0 Odor: slight solvent odor
★ Scope of application:
Clean margin ZB-25 is a special cleaning agent for electrical equipment, widely used in Petrochemical Machinery, electricity Chemical industry Automobile, shipbuilding, * * *, aviation, * * * Instruments and Apparatuses , household appliances and other fields clean transport Substation equipment, motor, distribution cabinet Solenoid valve Doors electrical Switches Electric tools, terminal blocks Air conditioning unit And other equipment.
★ Usage:
Clean margin ZB-25 Direct cleaning or immersion cleaning is acceptable. For direct cleaning, the dust and sundries in the electrical equipment department can be blown off with a spray gun or leather tiger, and then cleaned from bottom to top with a spray gun or spray pot. Small motors or dismantled electrical equipment can be immersed in Clean margin ® ZB-25 can be completely cleaned in a few minutes.
★ Suggestions from relevant persons:
1. Jieyuan ZB-25 is a chemical product and should not be taken orally. Keep out of the reach of children.
2. In order to reduce accidents caused by improper operation, please cut off power for cleaning as far as possible. DC and HV motors, abnormal heating and dirt
Serious electromechanical equipment, especially in humid places, must be powered off for cleaning.
3. If the carbon brush of the motor has been worn out and the spark is serious, please replace it in time and clean it.
four Compressed air shall be free of moisture or dried. External connection of spray gun 0.4-0.6Mpa Compressed air OK, do not press
Too much force to avoid Clean margin ® ZB-25 Splash waste.
five Blow off a lot of dust and sundries before cleaning, which can save Clean margin ® The usage of ZB-25 reduces the cost.
6. After cleaning, use a spray gun, watering can, and hair dryer to air dry the residual liquid completely or naturally, and then connect the power to use the equipment.
7. After cleaning the bearing and other parts, check whether it is necessary to add lubricating oil.
8. Please wear rubber gloves when you have a wound on your hand or use it for a long time.
nine Pay attention to ventilation on site Open fire is strictly prohibited. The waste liquid can support combustion and be discharged carefully.
ten Oil resistant The rubber, plastic and glass parts of agricultural production system shall not be soaked or cleaned.
11. It cannot be used for cleaning accurate electronic instruments.
12. Below 40 ℃ Store in a cool and dry place, and clean the edge every time ® The ZB-25 shall be sealed and packaged to avoid volatilization.
13. Please consult with the technical personnel of Beijing Zhubao Company before using in large quantities