Antistatic PEEK Plate, anti-static PEEK stick

Polyether ether ketone (PEEK) is a linear aromatic polymer. The main chain of its macromolecule contains a large number of aromatic rings and polar ketone groups, giving the polymer heat resistance and mechanical strength; In addition, the macromolecule contains a large amount of ether key And endow the polymer with toughness. It is a high temperature resistant thermoplastic with high Glass Chemical transformation temperature (143 ℃) and melting point (334 ℃), load thermal transformation temperature up to 316 ℃, can be used at 260 ℃ for a long time. PEEK resin not only has heat resistance ratio other High temperature resistant plastic is good, and has high degree, high modulus, high fracture toughness and excellent dimensional stability; PEEK resin can maintain high strength at high temperature. Its bending strength at 200 ℃ is about 24MPa, and its bending strength and compression strength at 250 ℃ are still 12~13MPa. PEEK resin has high rigidity, good dimensional stability, and small linear expansion coefficient, which is very close to the metal aluminum material; It has good chemical resistance. Among ordinary chemicals, only concentrated sulfuric acid can dissolve or destroy it. Its corrosion resistance is similar to that of nickel steel. At the same time, it has flame retardancy. It emits less smoke and toxic gas under flame conditions, and has strong radiation resistance; PEEK resin has good toughness and excellent fatigue resistance to alternating stress, which is superior among all plastics and comparable to alloy materials; PEEK resin has outstanding tribological properties, good resistance to sliding wear and fretting wear, especially high wear resistance and low friction coefficient at 250 ℃; PEEK resin is easy for extrusion and injection molding, with good processing performance and high molding efficiency. In addition, PEEK also has good properties such as good self-lubricating, easy processing, stable insulation, hydrolysis resistance, etc., which makes it widely used in industries, aerospace, automobile manufacturing, electronics and electrical, health and food processing.
1. PEEK1000 (brown grey) PEEK1000 is made of pure polyetheretherketone resin, which has good toughness and impact resistance in all PEEK grades. PEEK1000 can be sterilized by more convenient disinfection methods (steam, drying heat ethanol And Y ray), and the ingredients of the raw materials used to manufacture PEEK1000 comply with the provisions of the European Union and the US FDA on food adaptability. These characteristics make it suitable for health, pharmaceutical and food processing industries and widely used. 　　
2. The result of adding PTFE, graphite and carbon fiber to PEEKHPV (black) makes PEEKHPV a bearing grade plastic. Its superior friction properties (low friction coefficient, wear resistance, high peak pressure limit) make this level of friction application field an ideal material. 　
3. PEEKGF30 (brown grey) This material is filled with 30% glass fiber reinforced plastic, which has better rigidity, creep resistance and dimensional stability than PEEK1000. It is ideal for manufacturing structural parts. It can bear fixed load for a long time under high temperature. If PEEKGF30 is used as the sliding part, its adaptability should be carefully checked because the glass fiber scratches the fitting surface. 　
4. PEEKCA30 (black) The material is filled with 30% carbon fiber and reinforced. It has better mechanical properties (higher elastic modulus, mechanical strength and creep) and more wear resistance than PEEKGF30. Moreover, the plastic reinforced with carbon fiber has 3.5 times more thermal conductivity than the unreinforced PEEK plastic and can dissipate heat from the bearing surface faster.

Origin: Germany/Switzerland/Japan