Basic introduction of C-shaped steel punching and twisting machine:
1. Seven roll leveling of C-shaped steel punching and twisting machine Flat Good effect. The transmission adopts a movable coupling, which can automatically disconnect from the main machine to avoid the difficulty of equipment operation caused by non synchronization
2. Roll mold: Gr15 (bearing steel) is used with high hardness and good wear resistance. Generally, there is no obvious wear within 2 years. Hard chromium plating on the surface can also increase wear resistance
3. The host is external Nut Adjustment and model change are fast, convenient and practical key It is made of 45 # steel by fine turning, quenching and wire cutting, with high hardness and no bending
4. Adjusting sleeve: snap type, easy to disassemble, good interchangeability, not easy to fall off, and easy to replace
6. High degree of automation, saving manpower, time and discharging standards
The strip steel is fed from the tail of the C-shaped steel punching and twisting machine, pressed into C-shaped steel by various pressure rollers, and sent out from the head. After gradually improving the production process, the automatic control of the whole process was finally realized, the production efficiency was improved by leaps and bounds, and the technical content and added value of the customer's equipment were increased. The improvement process is completed in three steps.
The length measuring device and flying saw are added to improve the front step. When the pressing length reaches the set length, the flying saw acts to automatically cut the profile.
The second step of improvement is to add a hydraulic punching device to punch four holes at a time. The flying saw cuts through the middle, thus forming two side holes at the head and tail of two adjacent sections of C-shaped steel.
The third step is to improve, add another equipment to punch the middle holes according to the spacing set by the user during the strip steel pressing process, and the larger one can punch 16 middle holes.
The fourth step of improvement is to change the side hole 4-hole punching die into a 2-hole die according to the requirement of the new C-shaped steel to punch double holes in the middle of the profile, and modify the side hole punching program, so that the side hole punching equipment can punch double holes in the middle, and the hole spacing is set by the user, so that 8 groups of double holes can be punched when the hole spacing is large. In this way, all requirements of C-shaped steel can be met.
Xuri Tile Pressing Machinery Co., Ltd color steel tile Equipment, tile pressing machinery, cold bending forming equipment, Metal forming equipment , floor bearing plate equipment, glazed tile equipment, angle chi tile pressing machine equipment, double-layer color steel plate equipment, profiled equipment, container plate equipment, dust removal box plate equipment, automobile box plate equipment, water tank plate equipment, plate shearing machine/bending machine equipment, C/Z/U type equipment, etc. Sales Tel.: * * * QQ: 1051311440 Welcome to inquire. Website: http://www.hbxrywj.com
