summary: This product is modified polyurethane Acrylic acid ester Anaerobic adhesive , single component, light curing, easy to use.
Performance characteristics: The product is used for thickening the original sheet, lamination edge grinding crystal Crafts Glass Decoration, glass candlestick, TV cabinet and other glass materials are bonded to glass products. Good water resistance, no degumming, not easy to break.
Scope of application: Lidun BB series is a single component UV curing or visible light curing adhesive, which is easy to use. The lamination is mainly used for bonding transparent materials such as glass and glass or between transparent and opaque materials.
Performance parameters: model | colour | Viscosity (25 ℃) | Curing time | Curing conditions | Torque (Nm) | Substrate | Erect a shield ® BB101 | Colorless or yellowish | 80 MPa. s | About 15s | UV/visible light | > 18 | Imitation painting/crystal/glass bonding | Erect a shield ® BB400 | Colorless or yellowish | 400MPa. s | About 10s | UV/visible light | > 22 | Crystal/glass/facade glass bonding | Erect a shield ® BB800 | Colorless or yellowish | 1000 MPa. s | About 15s | UV/visible light | > 22 | Glass/metal/facade glass bonding | Erect a shield ® BB010D | Colorless or yellowish | 1000 MPa. s | About 15s | UV/visible light | > 23 | Glass/metal/facade glass bonding |
usage method:
A It can be used after opening the can without further mixing, so as to avoid the formation of bubbles by mixing air and causing defects on the joint surface. B The joint surface must be completely clean and free of dust and grease, otherwise the joint effect will be affected. (If necessary, use solvent, acetone, etc. to scrub the bonded interface). C . When jointing, first apply the adhesive on one side, and then fit the other side. After being irradiated by ultraviolet light 5-30S Fully cured. If the assembled items are easy to move and slide after being glued, they can be illuminated by a black light tube eight -15S As a pre fixation, it can be cured under ultraviolet light to reduce the rate of defective assembly.) D After the adhesive is unsealed and used, the lid of the tank shall be locked to avoid moisture affecting the quality. E . The adhesive shall be placed in a cool and dry place to avoid direct sunlight. F The curing time is affected by factors such as the thickness of the article, the distance between the lamp source, etc. The length of the ultraviolet light exposure time must be tested in advance during the production operation. Pay attention to monitoring the ultraviolet light intensity of the light source. matters needing attention: one Pay attention to the thin and even glue application during use. two The product shall be stored in a cool and ventilated place with dark packaging and avoid direct light. | 
