JMH-05 Special use of tile adhesive Colloidal powder
Product features
JMH-05 adhesive powder specially used for ceramic tile adhesive is cement As a gelling agent, a new ceramic tile adhesive made by adding high molecular polymer and inorganic powder as water retaining agent and adhesive can also be used for thin layer bonding of ceramic tiles. Scope of application This tile adhesive can be widely used in concrete mortar Tiles are bonded on walls, floors and various wall panels.
Product description
1. High bonding strength. The bonding strength is about 2-3 times higher than that of pure cement.
2. Good construction performance. This product has good water retention, workability, and resistance to falling, and can be adjusted for about 20 minutes.
3. Cost saving. Since the adhesive powder belongs to thin layer bonding, the dosage can be greatly reduced and the cost can be saved.
4. Good durability. This product has a certain flexibility, and because it is thin layer bonding, its resistance to deformation is enhanced, so it has good durability.
Technical indicators
Usage and precautions
1. Base course treatment: the base course shall be solid and flat, free of floating ash, soft layer and oil stain, and large cavities shall be repaired in advance.
2. Slurry preparation.
3. Tile bonding: paint the mixed slurry on the base surface with a tooth shaped trowel to make it evenly distributed and combed into stripes for air removal. Scrape a thin layer of slurry on the back of the ceramic tile, and bond the ceramic tile to the base surface before the base slurry dries. Note that the entire back of the ceramic tile is fully sealed with the ceramic tile adhesive, leaving no gaps. Generally, the tiles do not need to be pre wetted by soaking in water before bonding, and only need to clean the surface of the tiles.
4. Pointing and cleaning: the same as the traditional operation process, but the pointing should be dense, full and smooth.
5. The thickness varies with the brick material, general Marble : The binder should be 5~7mm, the face tile: the binder should be 3~4mm, the floor tile: the binder should be 5~7mm, and the setting time is related to various factors (temperature, dryness). Generally, the initial setting time is 5~6h, and the final setting time is 24h Square brick The vehicle can only be driven after a week. Do not construct when it rains. The construction temperature should be above 5 ℃.
Application Reference
1. Reference formula of tile adhesive
① PO42.5 ordinary silicon cement 500KG/T
② Medium sand 500KG/T
③ JMH-05 Special glue powder for ceramic tile adhesive 10KG/T
④HPMC 2-4KG/T
2. Reference formula of tile jointing agent
① PO42.5 ordinary silicon cement 400KG/T
② Medium sand 400KG/T
③ Fly ash 200KG/T
④ JMH-05 Special glue powder for ceramic tile adhesive 10KG/T
⑤ HPMC 2-4KG/T
(Pigments of different colors and weights can be added according to construction needs)
Packaging and storage
1.25 KG, chemical composite paper plastic packaging bag, lined with PVC film;
2. The warranty period is 2 years, and it must be waterproof and moisture-proof. After opening the package, it must be tied and sealed, smelly and harmless.
