GST Modified epoxy potting adhesive
Seam sealer base Plug Grouter
Product use
Applicable to filling >0.5mm Structural micro cracks can also be used for mortar, concrete and brick hollowing
Grouting and reinforcement treatment shall be carried out for cracks and other conditions.
Executive standards GB50367-2006
construction technology
1、 Material allocation:
one According to component A: component B =4 : one The product can be used after being mixed evenly.
two According to the actual width of the cracks on site and the construction conditions, an appropriate amount of dilute can be added into the epoxy resin mixture
Release agent (such as acetone, xylene, or resin specific diluent) shall be diluted to reduce
Grease viscosity, easy to pour.
three The one-time mixing amount shall not exceed 500g As appropriate, it can be used as needed , Incipient consolidation 24h, Fully cured 5~7 day ,
If the one-time dispensing amount is too much , The initial setting time will be shortened accordingly.
matters needing attention
one This product is applicable to five Environment above ℃, below five Temperature rise measures shall be taken at ℃.
two If there is water on the concrete surface, it should be wiped off and dried with a hot air blower.
three Pay attention to ventilation in the use place, and wear protective glasses, gloves and mouth tightener when using
Wash hands immediately after using this product.
four In the process of construction, if it is accidentally splashed on the surface or in the eyes, it should be immediately washed with a large amount of water
Those who are serious should seek medical advice in time.
Packaging, storage and transportation
one This product is packed in iron drums, and the packaging specification is each set 12kg 3kg/ Group, or each set 4kg 1kg/ Group.
two This product is not flammable and dangerous. It can be transported by air, * * * and road. It should be light during transportation, loading and unloading
Keep it away from rain, sun and upside down.
three . The product is stored at room temperature and has a shelf life twelve Months. If it is beyond the warranty period and passes the test, it can still be used
use.
Features of sealant products
This product has high hardness, good polishing, fast curing speed, strong adhesion, and is easy to mix with concrete, stone
Material, steel plate and other base materials can be bonded at low temperature( -10 ℃ -45 ℃) construction.
Product use
one . It is used to seal various concrete cracks, joints of steel plates and various brick plates, and for non important structures
The reinforcement at the position shall be embedded and fixed.
two It is used to seal cracks and bond the base in the grouting repair construction of concrete structure cracks.
Executive standards GB50367-2006
usage method
take one hundred Part A and three Part B (curing agent). Mix and mix well before use.
matters needing attention
one The surface of the adhesive shall be clean, dry, and free from looseness, oil stain, etc.
two When the product is placed in a fire, it will react violently and release carbon monoxide and carbon dioxide.
three According to actual needs, the amount of curing agent can be increased or reduced to control the curing speed.
four When mixing materials, it is better to mix them at any time, and it is not allowed to mix all materials A and B at one time.
five . If it is not used up at one time, the cover must be covered after use so that it can be reused next time.
★ Relationship between fracture width and injection port spacing
Crack width( mm ) 0.1-0.3 0.3-0.5 0.5-1.0 1.0-3.0
Injection port spacing( mm ) 10-20 20-30 30-40 40