Extra long straight groove elasticity pin This is a large product, and it is also a new product developed by our company. If you can find it useful, you are welcome to order from our company
The relevant manufacturing and parameters of the extra long straight groove elastic pin are as follows:
Application of straight groove elastic pin
ISO 8749、GB/T13683、 AS ME B18.8.2、ASME B18.8.4M、 The shear test procedures specified in SAE J496 and NASM 10971 are roughly the same. The shear value of * * * can only be obtained under the conditions specified in the referenced standards.
special Don't mention:
* The gap in the shear plane must not exceed 0.15 mm or 0.005 ".
* The hole diameter must be nominal cylinder Pin diameter (tolerance H6), its hardness shall not be small HV 700。
* The distance from each shear surface to its end face shall be at least one cylinder Pin diameter size, The distance between the shear planes shall be at least the diameter of two cylindrical pins.
*ISO 8752 cylindrical pin shall make the notch upward when conducting shear test Shear load alignment.
* ASME B18.8.2, ASME B18.8.4M, NASM 10971 and SAE J496 cylindrical pin shall make the notch relative to the shear load direction during the shear test Rotate 90.
Straightness specification
(ASME straight pins only) The straightness over the entire length of the straight pin shall Meet the following requirements, that is, the cylindrical pin can freely pass through the length and diameter specified below Circle of Gauge 。
Welcome to consult Manager Li http://www.peifengwujin.com Elastic pin