Tongchuan High pole lamp Manufacturer: 1819226826 Tongchuan High Rod lamp Manufacturer Shaanxi Oulang street lamp Professional Tongchuan High Pole Lamp Factory Shaanxi Oulang Road Lamp Factory pin Sell all kinds of high pole lights, middle pole lights, stadium lights, Square lamp , landscape lights, garden lights, antique lights, lawn lights, buried lights, underwater lights, project lights, floodlights and other outdoor lighting products, welcome customers to customize with drawings and samples!
Contact: Manager Zhang Mobile: * * * Tel.: * * * QQ: 506252456
Tongchuan High Pole Lamp Factory Shaanxi Oulang Road Lamp Factory High Pole Lamp Product Introduction:
Lamp pole height: 18-40M, the lamp pole is hexagonal or octagonal
Process: hot galvanizing, corrosion prevention and rust prevention, ten year warranty
Light source appliance: Shanghai Yaming 1923/Philips
In the rectangular cavity at the bottom of the lifting high pole lamp, in addition to the electrical control system, the lifting system such as the motor is also installed. The electrical control system is installed inside the lamp pole, which can avoid the failure of lifting movement caused by bad outdoor environment. The electrical control system is equipped with various circuit overload protection devices. Copper based silver plating is widely used as the conductor of the circuit in the system to ensure good contact of electrical connection. The lifting system of the lifting high pole lamp drives the lifting of the lamp panel through the motor, (electromagnetic braking) worm gear reducer, safety coupling, main wire rope, auxiliary wire rope, rope splitter, movable pulley block and other components. The worm gear reducer has strong self-locking capacity, compact transmission, and large transmission ratio. In order to reduce the worm gear and worm speed ratio, and reduce the rising torque, a group of moving pulleys are specially added, so that the lifting speed of the lamp panel is less than 0.2 m/s. The main steel wire rope is connected with the auxiliary steel wire rope of the lamp panel through the rope divider, which can avoid the winding of the auxiliary steel wire due to the tension of the main steel wire. The main and auxiliary steel wire ropes are 6 * 19 non rotating galvanized steel wire ropes with high corrosion resistance. The lifting pulley blocks are made of A3 steel brackets, stainless steel shafts and copper pulleys that have been hot-dip galvanized to ensure that they can operate flexibly without corrosion under normal atmospheric conditions. All kinds of fasteners, washers, ferrules and other parts are also hot-dip galvanized or stainless steel. The lamp panel is equipped with 6 groups of guide pulley blocks and more than three groups of braking devices. The guide wheels distributed at 120 degrees roll along the surface of the lamp pole during the lifting or lowering of the lamp panel to ensure that the lamp panel does not swing. The surface of the working part where the guide wheel of the lamp panel contacts the surface of the lamp pole adopts the rubber hot pressing process. In order to fully ensure the automatic stop of the lamp panel when it reaches a limited position, the lamp panel shall be equipped with reliable limit switches for ascending and descending movements, and shall be equipped with over travel protection. The lifting of high pole lamp panel is realized by changing the rotation direction of the motor. In order to prevent theft, the rectangular cavity is equipped with a sealed door, which is equipped with a special door lock.
The lifting high pole lamp is equipped with manual and electric lifting control modes, so that the lamp panel can be safely and reliably lowered to 2.5 meters above the ground for easy maintenance. The length of the outgoing line of the manual remote control device is 10 meters. The operator can remotely control the lifting of the lamp panel at 5 meters to ensure the personal safety of the operator. The lifting high pole lamp is also equipped with a spare cable. When the lamp panel is lowered to a lower position, one end of the cable is inserted into the socket of the electrical control system, and the other end is inserted into the junction box on the lamp panel, so that the lamp panel can be
