Installation instructions of three end grinder:
This machine is sold as a whole after assembly and commissioning by the manufacturer. When receiving this machine, the user should carry out necessary inspection, mainly to observe and eliminate the possible impact during transportation. The machine is well placed on the workbench with exhaust dust removal device. This machine does not need special foundation installation, clean the packaging grease, and connect the power supply and ground wire before connecting the belt. Test run, make the motor run in the calibrated direction to prevent the motor from reversing. Reverse rotation of the motor may loosen some connectors or damage the equipment. After confirming that the running direction of the motor is consistent with the calibrated direction, the motor belt can be installed for commissioning.
Instructions for three head grinder:
one Loading: turn the grinding head Lift up the seat cover Go on, take down the mortar Upper cover Put the material to be ground into the mortar Inside, put on the cover and put down the grinding head.
two Grinding: start the motor and turn the clutch handle clockwise , the friction clutch can be closed, so that the grinding head , mortar , the material is ground by rotation.
three Unloading: turn the clutch handle counterclockwise , disconnect the friction clutch and grind the rod And mortar Stop the movement. Lift the grinding head Remove the bowl cover Put the receiving container on the corresponding position of the receiving rack, and rotate the long handle on the left of the mortar , make mortar Rotate and lift it to the top of the feeder, brush the powder in the mortar into the feeder with a brush, and then discharge the mortar Reset and start loading again.
four . Indexing: when the grinding head needs to be shifted due to the motor running, just press the handle sleeve located at the lower left of the material receiving rack with your left hand , the upper part of the mill can be transferred automatically one hundred and twenty ° That is, when the other mortar reaches the unloading position, it will stop automatically. If the motor needs to be shifted when it is not running, the operation method is the same as before. In addition, it needs to gently turn the right hand to lower the rotary table.
matters needing attention:
one When the grinding head is lifted, it must be kept stable; When the grinding head is put down and the mortar is reset, it must be handled with care. Otherwise, the mortar and grinding stick will be damaged.
two After the work is completed, the grinding head must be put down, the three friction clutches must be disconnected, and the power switch must be checked to see if it has been turned off. Cover the equipment with a hood.
three Bearings on motors and grinders, per one ～ two Clean and change the oil once a year.
Safety rules:
one Operators of this machine must receive safety technology education and carefully read this manual.
two It is strictly prohibited to repair and dismantle the equipment during operation.
three The electrical facilities of the machine should be well grounded, and the wires should be installed in the insulated pipes.
four According to the standard, users of electrical safety protection devices and personal safety protection devices should solve the problem according to the site conditions and check the settings again. Check whether the safety protection device of the original equipment is reasonable and intact according to the working environment, and eliminate the hidden danger immediately when it is found.
