Clamp Connector ：
1. Fast without welding and re galvanizing, installation speed ratio flange Connected pipe fitting More than 3 times faster. 2. Simple It is lighter than the flange, and the locking mechanism is designed ingeniously, Bolt Small quantity, no need to pair holes and locks. 3. Reliable ① The clamp Washer It is pressed with the groove at the pipe end in full circumference, and the tensile strength of the pipe end is large, the test pressure is up to 4.2MPa, the temperature is - 30 ℃~100 ℃, and the vacuum degree is up to 0.08MPa; ② The gasket is designed as C type, which can form triple leakage prevention. The greater the pressure in the pipe, the better the sealing; ③ The gasket can be properly selected according to the fluid medium, pipe material and temperature. 4. Vibration isolation and shock absorption ① Since there is a gap at the end of the pipe, the transmission of noise and vibration can be effectively cut off, and the pipe will not be affected during thermal expansion and cold contraction; ② The sealing gasket can also absorb noise and vibration. 5. Economical, safe and convenient for project budget, saving 20% of the total project cost compared with flange connection, and no power, oxygen and open flame are required for construction. 6. Zero pollution Since there is no welding slag or damage to the zinc coating and plastic coating during the installation of the original parts, it can ensure that the pipeline is unblocked. The connected pipeline, especially the fire sprinkler system, will not rust and block the equipment and sprinkler heads in the pipeline due to other connections. 7. Less space occupied ① Flange installation space is 3:2 than clamp joint. ② The clamp joint and accessories can be installed first, and can be adjusted in any direction and angle. The piping is optional. 8. It is convenient for maintenance, cleaning and replacement. Only two clamps and four bolts need to be removed to facilitate the extension, replacement and rotation of the pipeline. Wear evenly. 9. The piping is complete. The specification of clamp fittings of our factory is DN25~600, and special specifications can be customized.
