Aluminum coil suction cup carrier, fin machine aluminum coil feeding suction cup spreader

one Design Criteria

The equipment of the company is strictly in accordance with European CE standard EN13155:2003, the United States AS ME (Mechanical Engineering Association) B30-20-2006 standard and German UVV18 standard, the main design index is higher than the above standards.

(1) Safety factor: the main body is greater than 4.0, the calculated pressure value of vacuum system is 60%, the actual high pressure can reach 80% vacuum degree, and about 40% margin is reserved.

(2) Coil overhang

The unwinding of the coil is related to the rolling tightness and width of the coil, and the overhang is about 200mm according to the design of 16mm wide aluminum coil

five point two Equipment characteristics

● Mechanical part:

(1) The equipment is equipped with a vacuum accumulator, which can reliably absorb coiled materials for at least 5 minutes when the equipment is suddenly powered off, without causing safety accidents such as equipment damage (the European CE standard is for 5 minutes)

(2) Electric push rod - DC electric machinery Drive, stable, reliable, clean, low noise. In the process of overturning, the impact is small. Button control mode.

(3) The left and right lateral moving mechanism is convenient for the operator to align the axis of the fin machine, eliminating the displacement of the trolley position, which requires reversing and repeatedly aligning.

(4) Forward moving mechanism: when the suction cup is close to the fin machine, after the centering operation is completed, it is not necessary to move the vehicle forward and backward, and a separate electric push rod is used to control the suction cup to move forward and send the workpiece to the fin machine smoothly.

(5) Camera system, the trolley moves to the axis position of the fin machine to facilitate the operator to observe the axis of the fin machine. Through the camera, it is convenient to control the left and right, front and rear, up and down fine adjustment.

● Electrical part

(1) The trolley uses DC24V accumulator Battery ，120AH。 It takes about 12 hours to charge the battery to its full value, and the battery power can be seen and displayed by the electricity meter. The theory is used continuously for about 6 hours.

(2) Position interlock: the workpiece can be turned over only when it is lifted to a certain height to ensure no interference. When the workpiece is vertical, it shall be lowered to ensure that the workpiece does not touch the ground.

(3) Vacuum Van Vacuum pressure is installed on it switch And buzzer alarm unit. When the pressure of the vacuum system does not reach the set pressure, or when a power failure accident occurs, the alarm unit will control the red alarm to light up, and the buzzer will sound to prompt the operator to dispose in time.