Manufacturer of building water stop glue @ manufacturer of building water stop glue * * @ professional manufacturer of building water stop glue
Manufacturer of water stop glue for construction Good water stop effect. It has the double water stop mechanism of elastic rubber water stop and self volume expansion seal after encountering water. It has strong water pressure resistance ≥ 1.5Mpa, strong durability and low mass change rate. The water stop glue for building contains urethane coupling chain with special grafting technology, which will not cause loss of expansion element during long-term use. At 20 ℃, the theoretical life is 100 years. Easy construction: single component Paste. Standard caulking glue construction gun or putty Good cohesiveness of knife caulking construction: it can be firmly bonded to the foundation surface such as concrete, and has low requirements for the moisture content of the foundation surface. It can also be firmly bonded when it is wet. Scientific and environmental protection: it has good chemical resistance: it can resist chemical media such as hydrochloric acid, seawater, * * *, potassium hydroxide, etc; It can be directly used in drinking water engineering, safe, * *, and environmentally friendly. Good cost performance: better performance than traditional Construction joint Waterproof materials, such as steel edge rubber waterstop or waterstop, are moderately priced.
Manufacturer of building water stop glue @ manufacturer of building water stop glue * * @ professional manufacturer of building water stop glue Scope of application:
Sealing of structural joints and plugging of pipe leakage, such as rough or smooth structural joints in concrete castings; Seal the joints between prefabricated parts (such as manhole, box type blind ditch Cable Trench The Conduit Etc.); Joints around H-shaped steel; seal up Bolt Or voids around pre cast holes; Sealing of orthogonal pile wall; Waterproof, leakage and sealing of underground tunnel works.
Manufacturer of water stop glue for construction Construction method:
1. The dust and oil stain on the surface shall be cleaned before construction, and there is no special requirement for flatness, dryness and wetness.
2. Put the sealant into the glue squeezing gun, screw on the glue nozzle, and cut the size and width of the glue nozzle according to the joint requirements.
3. Use the glue squeezing gun to squeeze the sealant into the construction joint.
4. The applied sealant shall not contact with water until it is cured.
Manufacturer of building water stop glue @ manufacturer of building water stop glue * * @ professional manufacturer of building water stop glue packing:
400ml or 600ml flexible packaging or other packaging according to user requirements.
Store in a dry environment below 25 ℃ for 9 months.
Manufacturer of water stop glue for construction matters needing attention:
1. Avoid direct construction in rainy days and places in long-term contact with water to prevent sM-402 glue from expanding in advance.
2. If construction is carried out at the casting place, it shall be carried out 24 hours before pouring and tamping.
3. Be careful when pouring and vibrating concrete to avoid damaging the sealing of materials.
Manufacturer of building water stop glue @ manufacturer of building water stop glue * * @ professional manufacturer of building water stop glue @ Hengshui Hongji Rubber and Plastic Co., Ltd
Our company deals in various engineering waterstop materials, and provides quotations and samples of various engineering waterstop materials free of charge.