Long handle tap manufacturers sell customized taps in batches, which is a kind of lengthened tap. Usually, the handle is processed to achieve deep hole tapping or to make up for the defect of insufficient processing length. Although the long handle tap manufacturers sell customized taps in batches and deep hole taps are both the taps of lengthened handle, and even the appearance is the same, the tooth lines of the two are very different, Deep hole taps are all sold and customized by long handle tap manufacturers in batches, but not all of them are sold and customized by long handle tap manufacturers in batches. It may also be because the processing shaft is not long enough, or because it is too deep from the processing workpiece. Deep hole taps are better made into spiral grooves, because spiral grooves are easy to remove debris, and debris has a greater impact on the accuracy of tooth lines in deep hole tapping, The drive of spiral groove can allow the chips generated during processing to be discharged upwards, and the die can eliminate the interference of chips. The material of deep hole tapping is also required to be high, because the resistance of deep hole tapping is great, while the manufacturers of long handle tapping sell customized products in batches simply because the processing length is not enough, and the purpose of normal tapping is achieved by extending the handle of tapping. Therefore, Long handle tapping manufacturers sell and customize in batches, only one operation is to lengthen the handle, which has no effect on the tooth pattern parts. Moreover, because of the difficulty of production, most of them use straight grooves, while deep hole tapping is also called deep hole spiral tapping, because of the spiral groove with better chip removal performance. How to change the tooth pattern processing parts that long handle tapping manufacturers sell in batches, The whole process should be based on the actual situation of processing. Deep hole processing does not have the difference between processing most through holes or processing most blind holes. Basically, it is a situation where half of the through holes are blind holes. In addition, there is also a situation where even non-standard wire tapping processing through holes is not required to pay for. In this way, long handle wire tapping manufacturers should be clear before they sell them in batches, What do customers do when they sell customized products in batches by long handle tapping manufacturers? Is it simply because the physical length is not enough and needs to use an extended tap to process the tooth pattern, or is it because of the deep hole tapping? It is not necessary for long handle tapping manufacturers to sell customized products in batches. Ordinary physical extension can use an extension rod to lengthen the handle, but the extension rod, whether white steel or tungsten steel, There are always cases of vibration. The longer the vibration is, the greater the vibration amplitude will be. Especially at the tooth mark part at the bottom of the shaking, the extension rod can also be used, but not too much. The deep hole tap really needs to be customized, because the ordinary tap is not only not smooth in chip removal, but there are few cases of tooth plugging when increasing the tap, In addition, as the contact surface between the tooth pattern and the workpiece is too long, the probability of the tap breaking is very high. Therefore, the manufacturers of long handle tap sell customized deep hole taps in batches, which need to be customized http://www.dgdaoju.com/ Please specify the forwarding
