Silicone heat transfer printing adhesive , silicone hot stamping Hot melt adhesive , Silicone transfer printing material:
Garment silicone heat transfer printing processing includes the following products:
one Silicone special use film
two Heat transfer silicone
three Silicone interlayer
four Silicone glue
five Silica gel hot melt powder
Operation steps
one , press the silica gel and color paste The required proportion of color shall be evenly mixed, and then added to the total mass of silica gel and color paste 10% curing agent , stir evenly.
two , will The color adjusted silicone screen is printed on the silicone release film. Each time of printing, bake until the surface is dry, until the desired effect, thickness and color are achieved, and then bake thoroughly.
three , heat transfer coating with silica gel The adhesive (cyclohexanone can be added if it is too dry during silk screen printing) is evenly prepared at 2.5%, printed on the silica gel surface, and baked until it is dry. Print again and bake until the surface is dry.
four , apply hot melt adhesive cyclohexanone Dilution, Screen printing on transfer adhesive Water meter The surface shall be printed once and baked until the surface is dry. Print again and bake thoroughly.
five , remove the film and put it into the oven, one hundred and fifty Degree baking thirty Minutes, and then transfer after cooling. one hundred and sixty Degree press ten Seconds. Tear off release film after cooling The transfer is completed.
