three hundred and three Strong ceramic tile Binder

303 American Tile Adhesive (High Adhesion)

Melico 303 strong ceramic tile bonding agent It is a kind of high strength, high flexibility and high polymer cement Base thin paste tile adhesive. Its high-performance ceramic tile adhesive is used for laying indoor and outdoor wall and floor tile works. Suitable for tiling Marble 、 Granite 、 Vitrified brick , porcelain tiles and homogeneous tiles, etc.

purpose

● Suitable for large size tiles and Stone Sticking

● Suitable for indoor and outdoor concrete , block wall cement mortar wall

● Applicable to floor tile Paving of

● Suitable for laying tiles, marble, granite, vitrified tiles, porcelain tiles and homogeneous tiles

● Suitable for cement-based Waterproof coating Tile pasting on

Performance characteristics

● Super bond strength

● High flexibility

● Good anti slip performance

● Good water resistance

● Improve work efficiency

● Extension of material construction time

● Green environmental protection products

Executive standards

● EU standard: EN 12004:2007 C2TE

● Chinese standard: JG/T 547-2005 C2TE

surface treatment

● The surface of the base material shall be flat, dry and clean, free of grease, floating ash, dirt and other loose materials.

● New concrete or block walls shall be cured for less than four weeks or wait for the completion of shrinkage before laying tiles.

● Melico 303 strong ceramic tile bonding agent The construction shall be carried out at least 7 days after the wall plastering.

● Before construction, pre wet the substrate surface with clean water and ensure that there is no exposed water.

Mixing ratio

take Melico 303 strong ceramic tile bonding agent 25kg/bag The powder is mixed with about 6 kg of clean water.

Use an electric mixer to mix for 5 minutes until completely mixed. It can be used after stirring for 5 minutes and then stirring for 30 seconds.

usage method

Use a sawtooth trowel to smear the adhesive on the substrate to make it evenly distributed. Each application thickness is about 2.5-6 mm， Then knead and press the tiles on the construction surface. It is recommended to conduct routine inspection every time to avoid hollowing, The entire back of the tile shall be fully bonded with the adhesive layer. When the surface of the tile adhesive is dry, do not spray the surface with water to avoid reducing or losing the adhesive force. Tiles are available 24 hours after laying Melico joint filler Caulking.

curing

Melico 303 strong ceramic tile bonding agent Good water retention performance, In general, watering is not required for curing, unless it is very hot or rapid drying occurs.

Coverage amount

About: 1.2 kg/m/ mm。

Packaging and Storage

Packed in 25kg bags, stored in a cool and dry place, and unopened products can be stored for 12 months.

matters needing attention
This product contains cement. Avoid contact with eyes or skin for a long time during use. Clean thoroughly after construction. If you accidentally get into your eyes, please immediately flush with plenty of water and seek medical treatment as soon as possible. Dust inhalation should be avoided. It is recommended to wear NIOSH approved respirator during construction. Avoid contact with children.