Shark master 688LC comments

The noise is relatively low. In standby mode, the temperature is 26 degrees. Master Lu tries his best to measure the temperature. The temperature is 38 degrees. The CPU is I5 2500K

If only the fans were a little brighter!

pretty good. I can recommend it to friends

The heat dissipation effect is very good, the installation and operation are relatively simple, and the noise is relatively low.

Prices are a little high.

I felt it was very good. I have recommended it to several friends.

1. Good heat dissipation effect, integrated design, convenient and safe installation, no need to worry about leakage. 2. The fasteners are fully supported, and all mainstream fasteners are supported.

1. The fastener design is good, the installation is not very convenient, and the workmanship is not very good. 2. The design of the cold exhaust is too small, and the heat dissipation is restricted. 3. The noise of the fan is loud, and the noise of the air volume is loud, which is really helpless. 4. The price is high, and the cost performance is not very good.

Very high-end products, good results, solid workmanship, water cooling is getting cheaper and cheaper, but still a little high, if it can be reduced to the level of air cooling, it would be great.

The weather temperature is not high, and I can't see how the heat dissipation is. It is generally about 26~35, which is not bad

The temperature is high and the noise is bigger than the original fan. I'm disappointed about this

It's just so so..