It is made of pure aluminum, and the number of fins is a little small. The silicone grease is very cheap, and the buckle is too hard. It took three times to buckle it up
summary
X is the cheapest pwm in Dongshang. It is equipped with a63650. When it is fully loaded, it turns to 2100. The air volume is enough and not too noisy. It is much better than the original fan
The small radiator has a very good heat dissipation effect. I use the I56 generation CPU, which has a good heat dissipation effect, mainly due to silence. Because of the smart wind, the control is pretty good, and the overall noise is very low
This is a four pin fan with a temperature controlled radiator. Although it is only an all aluminum alloy radiator, ordinary i3 level CPUs can be used. They don't generate much heat or make much noise
It looks very good.There is only a small episode during installation, because the heat sink of the motherboard is too large.It is not easy to get the heat sink snap off.The specific heat dissipation performance is not very clear.Take a while and then review it.
Small things have a lot of energy. First, the workmanship is very good. The heat dissipation iron underneath is very thick, which should be Lv's. Second, the size of the fan is also appropriate. The charging speed is fast. Third, the heat dissipation effect is very good, and overclocking is not enough.
It's quiet. The rotating speed range is about 1300-2100+. The 4pin intelligent rotating speed is still beautiful. The price is so affordable. It also has a heat sink and hook style. It's a perfect match for AMD.
Gospel of the old CPU.Very convenient.If the speed can be adjusted by four needles, that would be the best.But it's also very quiet.At.Video card fan.Cover the flash.Almost inaudible.It's pretty good.
The machine is too noisy and can only be eliminated a little bit.One of the noise sources is that the CPU fan is too loud. The original super cheap fan has no speed regulation function.The noise of the CPU fan has been significantly improved.However, the final result is that the chassis is still too noisy, and we have to continue to check
It's average. It's not much different from the original effect. Although the fan speed is reduced, the noise is not much improved.Then, the milling cutter mark on the fitting surface is clearly visible and very rough.I wonder if the mirror fit advertised by the manufacturer is different from our understanding.In a word, the heat dissipation effect is basically acceptable. The temperature of AIDA toaster is stabilized at about 66 ℃ for 30 minutes, and the room temperature is 27 ℃.
