Comments on the overclocking Three Yellow Sea Enhanced S90D

It's 69 yuan. I can buy a radiator with heat pipe and double fans. It's very affordable. I like the big one. This one is not too big. It's very easy to install. The Juechen x5 chassis can also be installed. It looks much fuller. I used the Swiss AC Freezer 13 before, which is easier to install than that. The mute is OK

The fan can't regulate the speed, and there are a little few heat pipes (hehe, this is a little reluctant, and the ideal one needs more money)

It is suitable for the use of the midrange CPU of amd. It is enough. When I press x3 425, it can overwhelm 27 degrees. It turns more than 1900. I am very satisfied. Room temperature 19

1) With strong heat dissipation performance, four 8mm heat pipes are much better than those of Red Sea 10, Extreme Cold 5620 and Jiuzhou Fengshen Bingling 200/300 with two or three 6mm heat pipes. Pressing 3.4G four core Yilong 965 and 3.6 Yilong 955 black box, the room temperature is 10 ℃, the no-load temperature is 28~32 ℃, and the full load is 46 ℃, which is about 10 ℃ lower than the above radiator. 2) The price is becoming more affordable. At present, the retail price of Taobao's online stores is only about 80 RMB. 3) The mute effect is very good. Although there is no temperature control and self speed regulation capability, the working noise of the low speed fan with rubber damping fasteners and 1600 rpm large blades is very low - equivalent to that of the Red Sea 10 and 5620.

For beginners, the fasteners are difficult to install, especially for AMD motherboards. It requires some skills to remove the fasteners of the cooling tower. Of course, the fasteners of the Red Sea 10 are the same line of inheritance, and those that are used to overclocking three-standard tower radiators can be quickly disassembled.

On the whole, I am satisfied that as a four heat pipe air-cooled radiator, it can play its due role and effectively suppress 4/6 core high-frequency CPU on the basis of keeping quiet, which is enough.

As one of the radiators with a good price within 100 yuan, the dual fan makes the CPU always around 30. It also provides a variety of radiator bases, which enable users to adjust the four directions of heat dissipation. Note that the radiator base provided by this radiator is only supported by the large board, and cannot be installed on the small board.

The 3pin socket does not support temperature control, and there are only two heat pipes. If it is pressed on the motherboard by default, I have to remove it from the motherboard to install it. Fortunately, the card is tight!

69 The dual fan board can be adjusted in many directions, and the heat dissipation performance is good!

Low noise, large air volume, outstanding heat dissipation capacity. FX4100， From the default frequency of 3.6 to 4.3, the room temperature is 27 degrees. When the original fan is turned on, the temperature is 51 degrees. After changing this, the room temperature is 25 degrees, the standby is 30 degrees, and the temperature and pressure test is carried out with EVEREST Ultimate Edition. After one hour of operation, the temperature is 42 degrees. Even the standby temperature of the graphics card has dropped from 54 to 40.

Large size, difficult to install. On April 6, Liuzhou Haojihui Computer City started at 110

Nice stuff~

The temperature control is good. My X2250 standby was pressed to 17 degrees

There is still some noise, and the fan vibrates very much, although there are glue nails;
Slightly larger volume;

Later, I removed a fan and installed it on the video card, and replaced the original noisy fan on the video card. The effect was OK, ha ha
Recommend it

1. The appearance is cool. 2. The AMD platform is easy to install. 3. The noise is low. 4. I don't know why so many people say that the cooling effect is bad. I have an 8-core bulldozer, the chassis is cool and the NV Wuzunshen Limited Edition, and the CPU is only 27~30 degrees when it is on standby! Standby for two hours is only 29-38 degrees. Is your air duct design unreasonable?

1. The radiator is sharp and easy to cut
2. AM3+platform is not added on the package, but bulldozer can
3. The color of the fan is not good

Reasonable price, good heat dissipation effect

Amazon 69 is worth it.
The temperature control is very good, the sound is not very loud, the temperature control is very good.
Core 2 E8500 ultra 500 external frequency, 4.0 dominant frequency. At the beginning, an ordinary fan of TT was used. It was OK in winter and early spring. There was no problem, but it could not withstand the heat just as it started. When opening the dnf, it would be more than 80, and the program would automatically close. With this fan, the maximum temperature when testing full load was only 77, which was very good.
The rotating speed of the active fan is always 2100, and the passive fan is about 1800. The sound is not very loud.
It supports all types of CPUs on the market, including 1366 CPUs, and the fasteners are easy to disassemble.

It is not easy to install the ASUS p5e3 pro motherboard. The fan wanted to blow backward and out of the chassis, but it was blocked by the motherboard heat sink, which made it difficult to install it, and it was scratched by the handle of the motherboard heat sink. In addition, the fan is three pin, unable to control, not very good,

The price is cheap and the quantity is enough. People who want to buy radiators should not hesitate.

The 9CM fan has excellent mute effect and good heat dissipation effect. It is equipped with my X4 631 with a standby temperature of about 10 degrees and a full load of 30 minutes with a temperature of 45 degrees. In fact, it's very easy to install. The main thing is that if you press it to any end, there must be a neutral gear. If it's not really possible to install it,
Taobao 58 yuan

None

Very cost-effective

The small tower is designed with double fans, which makes almost no noise!
It is very suitable for M-ATX and small case friends!
It feels good to start with 80RMB this summer!
Press 240, power up silently, 3.5 OC, power on, standby, no more than 30, full load, but no more than 45!!!

No temporarily!

If you want to experience tower cooling, you may want to give it a try!

My i5-2300cup has a standby temperature of 29 degrees after installing this radiator, and runs a large game at 45 degrees (21 degrees at room temperature). I feel that the heat dissipation effect is fairly good;
It is quiet, much better than the one I used (the former one was a tractor, I won't tell which one was produced);
4 The copper pipes are fairly well made. I think they are still worth 100 yuan.

It's really not easy to install, especially for the small board of H67. There is a capacitor near the edge of the board and the circular bracket provided by the overclock III is too close. In fact, they are closely connected. After a long time, the fingernails are bleeding before they are stirred up.
I was worried about breaking the capacitor during installation. I hope the design can be improved in the future.

The performance and workmanship are very good, the bracket buckle design is not user-friendly enough, and it is difficult for users with poor hands-on ability to install.

The AMD620 does not overclock. It has 47 degrees of standby and more than 65 degrees of play. And it is equipped with double fans. I don't know if the U has been used for 3 years, which is a little aging. However, it is much better than the original radiator that has been used for three years.

It's not easy to install. I got a screwdriver to install it.

The radiator within 100 yuan is not bad.

1. The installation is not troublesome, at least do not remove the motherboard from the back of the screw.
2. The cooling effect is worthy of this price.
3. The noise is well controlled, but I can hear clearly in the dead of night.

Maybe I haven't used a better one, so I think it's pretty good. If the rotating speed can hover between 600 and 2000, unnecessary losses can be eliminated, and the noise should also be reduced a bit.

Quite satisfied!

Good heat dissipation, AMD X4 620, the original fan is started at 50 ℃, the room temperature is 18 ℃, and now it is started at 38 ℃. Obviously. Very low noise. Some people always say that the fastener is difficult to install, but they don't think so. It will be clamped with a little effort.

The radiator fin is easy to deform, and the three wire does not support automatic speed regulation

The mid tier CPU is absolutely OK, and the price is not very high

I bought it at Jingdong 98. Very good heat dissipation. I5 2300， Now the room temperature is 30, the U standby is 39, and the utilization rate is 55 at 68%. There are a lot of gunmen here. I'm still hesitating to buy it. The fact has proved that the radiator is not bad. (In the test, I was the 8 driver.)

It's hard to install it. The radiator on the top is deformed and cannot be pressed down. The clip of the base pops up with force. Finally, first install the base and radiator, and then press the base under the motherboard.~~!

In general, the 1155 platform is difficult to install, but its cooling performance is good. However, if the chassis air duct is not good, it is estimated that the heat dissipation effect will be greatly affected.

The price is cheap. I bought it in an outside store for only 50 yuan. The cooling effect is really good. With my E3, the cooling effect is obvious. Although Master Lu shows 34 degrees, the motherboard shows only 32 degrees, which should be a good choice

So far, I haven't found anything that I can't be satisfied with. If there are any, I hope to buy one and get one free? ha-ha

There are not too many gorgeous decorations, the weight control is good, and the multi platform support is good. It has always been the preferred recommendation for 95W and below CPUs!

Double fans are the main reason I like it. Double copper tubes are enough for the heat dissipation index of our ordinary household computers. The noise is low. Those who say the noise is high may be the resonance amplification effect caused by the loose connection between the motherboard and the chassis. In addition, it is worth mentioning that the heat dissipation effect is very obvious. Compared with the original CPU heat dissipation, the temperature can be reduced by more than 10 degrees. It's a very good product, and the price is very friendly. In addition, in terms of installation, it is OK to use a little force. It is not very difficult. If it can't be fastened, just skim the metal buckle with a pair of pliers.

I haven't found it yet.

If you want low price and guaranteed cooling effect, you can start!

Very satisfied. See the summary for details

No shortcomings

The performance, heat dissipation and silence are very powerful. The original standby temperature of the radiator is about 40 degrees, and it is about 70 degrees when running large stand-alone games. With this radiator, the standby temperature is about 34 degrees, the running temperature of large stand-alone games is about 45 degrees, and the straight drop is more than 20 degrees. All the above situations are in summer. For the AMD motherboard, it is really easy to install, and the snaps on both sides are just a question of which side to install first and which side to install later. The price is definitely worth recommending.

My 3570K is stable and over 5.0. There is no problem

Prices are a little expensive

Very good radiator

The sound is relatively low, and the fan is easy to remove and clean! Very good heat dissipation function!

Large volume

No need to change the fan