Comments on finalcool (cold) M08EVO matte M08EVO (0.8mm copper sheet, rubber ring free fixed type)

It's OK to use it. It's easy to install it. The hard disk is lowered several degrees.

It's easy to use. I used a?????, No problem at present. The hole is a bit too long, but it does not affect. Just pull it off directly.

It's so dirty. Are you serious about using materials? It's second-hand. I'm too lazy to return it

it 's not bad. One hour GTA, 2K full height 3440 * 1440 resolution, the maximum temperature and pressure for one hour play is 63 °. The hard disk is the top flagship desktop hard disk Hynix p44pro-2T (2048MB independent cache), but the hard disk is installed on the notebook. The remaining overheated feeling is that the ash has not been removed for a year.

Good, great. I'm worried that the 2T solid state in my notebook can't dissipate heat. I won't worry if I use this

How can it be described as a good word? My Gun God 8plus, with two disks added, is about 40 degrees at room temperature. After the original manufacturer's hard disk is added, the data after running is basically stable below 60 degrees, 58-59 degrees. The Acer Raider GM7, 2t, and the data after running can be maintained at an amazing 45 degrees, invincible. It is highly recommended that the Gun God 8plus is installed with 0.8mm

The thickness is appropriate, and the heat dissipation effect should be good. Let's use it first. It's not used yet. The weight is full. I feel the weight in my hand. The accessories are complete, and it should be good to use. It can be fixed, not bad

First of all, thank the boss for the small screws. I bought Dell without screws, and bought Hynix memory module without screws, which directly embarrassed me. Fortunately, the boss has screws for the radiator. The thing is very good, but it is still a little thick. After putting it on, the back cover is not tight. I can only remove the radiator glue and flatten it with copper pieces. I hope the copper pieces are about one or two millimeters thinner

A complete set of heat sink kit, and even some additional heat sink stickers and three fixing rings. The heat sink fits very well, and the size is just right. The heat dissipation effect is good. With it, my solid state will no longer have to run naked.

This M.2 2280 SSD heat sink for notebook computers is of good quality, and six pieces have been purchased for the Thinkpad P1 Gen6 notebook computer in the laboratory. It works normally after installation, with complete accessories and good heat dissipation effect.

Big brand! Trustworthy! The effect is super good! The truth is that you are expensive! Great merchandise!

It is the sixth time to purchase this 2280 SSD heat sink, which is used to install it on a notebook computer to cool M.2 2280 SSD. Good quality, equipped with heat dissipation silicone chip and screw light tools.

It can effectively reduce the temperature of SSD, and only 36 degrees can be achieved when the gunshot is in standby mode

The delivery is fast, the packaging is very good, and the price is particularly affordable. It is also good to have so many functions, worth buying

It was installed and I forgot to take pictures. The effect was good. The test went directly from 79 to 59, which was OK

It works fairly well, but you need to be careful not to use too much force during installation.

The price is very affordable, and the cost performance ratio is very high. It is considered as low price and will be repurchased

It's a very good thing and a trustworthy seller. Come again next time

One thing to say, it still works. My P44Pro standby temperature has been reduced by 6 degrees

I feel that the heat dissipation effect is very good, and the installation is convenient. I recommend going to the computer store to install it