Comments on finalcool (cold) TN80 matte TN80 (0.5mm copper sheet, thinner rubber ring free)

After shopping for a long time, I finally found that the radiator of this M.2 solid state drive was bought to add to the laptop. The ordinary laptop is too high to fit the special model. The copper material has several specifications. The thickness can be matched with two silicone grease pads, and this model is not tied. It is very suitable for free installation to see how many degrees can be reduced

The notebook adds 2280 hard disks, and the temperature is basically below 44 degrees after turning on. Because the test may damage the disk, the temperature of the hard disk when reading and writing speed is not tested.

It is OK to reduce the solid temperature by about 5 degrees in the notebook

It can only be said that the temperature has been reduced from more than 40 to about 40

The thickness is just right, and the heat dissipation of pure copper is also fast. The solid particles of Samsung are a little thicker, and if the thermal conductive silicon chip is pasted, will it be completely stuck?????  ? ‌‍‎‏  ?? ?????  ? ‌‍‎‏ 

Very good. The thickness is 0.8. There is still room on the ultra-thin book. It is neither thin nor thick. The heat dissipation is just good