I bought 120 360 water cooling before, but I bought 420 water cooling for the first time. I can't help but call it 14900k. The heat dissipation requirements are really high. The installation process is quite routine. I can only say that it is neither good nor bad
Before the replacement, the cooling effect became worse after several months of use. When I first bought it, the voltage was 13900k, usually 95-100, and then it was fixed at 99-101 ℃. If the machine was high and full load for a long time, the voltage would have to be reduced
Get a white machine for the family.,The chassis is relatively large, and the texture is OK. Anyway, the iron sheet is quite thin, especially the hard disk. When you twist the screws, you always feel that the support is not specially used to upgrade the old machine. It's fresh to change the chassis.Match it with another one at home.The chassis is quite large, the texture is OK.
It is specially designed to upgrade the old machine, so as to make a new picture of the chassis.Match it with another one at home.The chassis is quite large, the texture is OK.The 480 is water-cooled, and there is no 480 on the market.This chassis can be matched with water-cooling.
The i7 14700k overclock 5.7 runs R2330 minutes or so. The temperature is around 69. The fan is really powerful when it is fully loaded, but the noise is also a little loud????
I bought a case and water-cooling device at his home, and specifically asked if they could be installed. But when they arrived, they found they could not be installed. Now they still shirk the responsibility. There are fewer water-cooling screws and the replacement has not been replied for two days. It is true that the case and water-cooling devices have their own garbage disposal
**80. The only 480 cold exhaust in the whole network. In order to suppress 14900K, try it bravely.The secondary atmosphere is sufficient, and white is beautiful. Unfortunately, the wire and hub are not matched with white.The wind is strong, the temperature of 14900K hitting the wall is 80 ℃, and the power consumption is 300W.There is a bug. The hub is connected to the snowblower motherboard, but the Aochuang Center does not recognize it, so it cannot control the light
The default setting is 14900K, which is not related to the small core. The 5.7 run is very smooth, and the temperature is up to 71. I wonder if I can take out the old air-cooled top, or overclock it to see how much it can be pressed.
To be honest, it didn't meet my expectations, but it was OK. 1.33 full p5.8, and the packaging temperature of the e4.6ring50 toaster could be around 90, which was OK.The noise is a little loud, but it is acceptable. After all, normal daily use is far from the level of the toaster, and the fan will not be fully loaded.
Walkiri's water cooling is the representative of low price and good quality, and there is no problem in suppressing 13700k.I don't know where the confidence of those water-cooled brands that sell for two or three thousand yuan is from, but the effect is not as good as Walkiri's?
It is relatively large. It can only be placed in an open case.My u is 7950x, and the temperature of roast chicken is about 70-85, which is acceptable on the whole.It is not as severe as the medium pressure temperature pressure.In addition, we don't know how to manage the lines. Don't buy an open case, or it will be as ugly as me
The radiator is good, double baking does not reduce the frequency, playing games still hit the temperature wall, damn it.If power consumption is not limited, it is estimated that no radiator can hold 13900K
Overall evaluation: simple, beautiful Product performance: good.The freight arrived the next day soon. The plate is very thick and heavy without noise. The radiator is good. Double baking does not reduce the frequency. Playing games still hits the temperature wall. Damn it.If power consumption is not limited, it is estimated that no radiator can hold 13900K
The big is beauty, the more is good. For this 480 water-cooling, I specially bought the Walkieri case. The case layout needs to be complained about, but the water-cooling is very satisfactory. The 13900k limit temperature has not been tested by ansys, and will be added later
Extremely good performance. The only thing is that the installation instructions are somewhat general. I hope that the classification of various screws will be explained in the future
