Very good, fair appearance, nice rgb lighting, memory overclocking is worth buying a fan, worth buying!The quality is good. If your friends need it, you can recommend it!
The small green bar plus vest plus fan, tried 7600 34 44 44 56 plus fan, and then adjusted the maximum speed from 42 degrees to 32 degrees * * 777 over test, there should be room for improvement, but I don't want to disturb the vddq voltage anymore. It's too hard to touch
It has been a while since I received the product, and I will review it again. The effect is still very good. The previous motherboard can't be used, but it can be installed after a replacement. The heat dissipation effect is still good, but it is worse than the previous cat fan. This one has ARGB, and it is a little chromatic
Don't use the high-end motherboard with a quick detachable video card. The buckle doesn't fit in.It really has the effect.But full turn is really noisy
The fan is very well made, and there is also a sound insulation silicone cover. It supports argb synchronization, which is very cool. The memory cooling is about 8 °
There is still room for improvement in the wiring of this radiator. The power supply is big, 4 pins are too short, and the wiring is not more comfortable. Then the memory clip can be upgraded and more reliable. The fan rotation angle can also be increased a bit. There is nothing wrong with the rest
The memory fan is very easy to use. The original memory exceeded 4200 degrees when the temperature of the game soared to 55 degrees, and the game crashed. Now, with the fan temperature plummeting, the game is very stable, very recommended!
At first, I thought it was a frills. After all, it was pure white rgb, and there was still a certain distance from the memory module. Finally, it was powered by the big four D interface, not from the motherboard, and the constant speed was not noisy. The fan turned on more stably than * * 5.However, the effect of the adapter+12cm fan is similar to this one.The main reason is that the chassis can't press the adapter from the top, and there is no problem with the 5v three pin rgb.Beijing is very fast. I bought it in the morning and arrived in the afternoon.
I feel that the air volume is relatively small, but there is no noise. It is not very noisy. It is directly connected to the large D port. It can also run at full speed
Start to use 4-pin Pmw for speed regulation. The wind force is too small. Connect directly to port D for full speed operation. Silent!The memory temperature limit of roast chicken was reduced from 57 to 46, the daily use was reduced from 47 to 41, and the memory frequency exceeded 7000 from 5600
The heat dissipation effect is obvious, which is really helpful for D5 overclocking.It can not pass the * * 5 pressure test without this, and it can be over tested if it is added.And the noise is unexpectedly small, and the noise at full speed can be ignored.
The heat dissipation effect is very good, and the installation is also convenient. The only thing is that the light color is not very good, and there is obvious color difference.
The rack is directly clamped to the memory rack, which is useful, but you need to turn the rotation speed to full before using it.Voltage above 1.55 can be used. In fact, it can be used. Only when the memory has good heat dissipation can the frame number be stable.
Have you been carefully selected for a long time?,Finally, I decided to buy this product????,I was not disappointed after the arrival of the goods. They are very beautiful????,Fine workmanship????,Particularly satisfied????It's worth more than you can say. These four words have explained everything