Good. I removed the 9800+middle case and installed it. The sound is obviously low The temperature has also dropped, and the standby temperature is about 30 degrees. The full load of the game does not exceed 40 degrees The weather also has certain reasons. The basic game temperature is about 35 degrees
Most dissatisfied
It's a little heavy. It's not a fixed heat dissipation
summary
On the whole, I'm very satisfied with the heat dissipation and silence
The heat dissipation effect is excellent. The 12CM fan is optional, and almost no noise can be heard! The original cooling standby temperature is about 48 degrees, and now the standby temperature is about 36 degrees (The room temperature is about 22 degrees)!
Most dissatisfied
The volume is too large. It is the largest radiator I have ever seen! Installed on my 9800GTX+, it needs several PCI bits!
summary
More than 100 prices, a good choice! The public radiator cannot reach it! Those who like to do things can consider it!
The overclocking three Caribbean HP4-1226 is used on my ASUS 5750, 700/1150 overclocking to 850/1350,,, The chassis is standing, the silicone grease is coated very thick,,, Stand by 32 degrees, Top quality flying car 15 42 degrees,,, Bakery machine full load 48 degrees....Achieve the effect I want.
Most dissatisfied
One is too big, which blocks one of my video card slots.The high A and low N groups of the original group can not be replaced, and the physical acceleration will be over, which is very depressing. My chassis is just ready to be installed,,, and the chassis cover is holding the heat pipes up...But in this way, there is no need for anything to support...
look quite strong!If you want to use the case lying flat!Unless your video card is 220 or below 5550!
Most dissatisfied
Once you erect the chassis, the temperature of the graphics card will be 2-5 degrees higher than that of the original radiator. To put it bluntly, it is the problem of the heat pipe!I have to change to Accelero Twin Turbo Pro again, disappointed!!!
summary
Pirates of the Caribbean are not allowed to place the chassis normally!
1. The heat dissipation effect is good. In combination with the overclock III 12CM silent fan, my computer has been reduced from the original standby 52 degrees to 43 degrees, and the full load 97 degrees to 69 degrees, which can be said to be very obvious cooling, 2 Be quiet. The 12CM fan is only 1300 rpm. If you change a violent fan, it is estimated that the temperature will decrease. 3 Complete accessories, very convenient
Most dissatisfied
1. It is too heavy and extends too far outside, so the graphics card feels a bit sinking. The best thing is to find a chopstick or something, 2. It's too high. After installing it, the height of the graphics card is increased by 50%. The chassis is not large enough to be installed. My chassis is Hangjia Holy Flame III H105. The specification is 243 wide In the end, it was just a little bit too high to fit. It was about 0.3cm too high. It was a tragedy that the cover of the case could not be covered, so it was forced to cover it, but I was afraid that it would not be damaged,
summary
If you can reduce the height by 0.5cm, I think the cooling effect will not be much worse. Most people can cover the chassis
The heat dissipation is really good. The test was done, but the premise is that the chassis must be placed flat. In this state, the heat dissipation is very good. The extreme torture of GTS250 and FURMARK is basically 65
Most dissatisfied
Tragically, when the chassis was upright, the temperature could not hold down at all. The temperature soared all the way. It was obvious that there was a problem with the heat pipe design. I had already taken the initiative. The graphics card was replaced with the first version of the Sotai GTX460. The heat dissipation was AC bra, which was very good. You can see my review post.
summary
Don't buy this heat sink. You can buy it if your chassis is lying down for a long time
Low price, strong heat dissipation performance.My 9800GT original radiator stands by 56-58 degrees at about 26 degrees at room temperature, and plays games at 74-76 degrees.Don't dare to bake!After the Caribbean F128 fan is replaced, the invisible speed only shows 40%, the standby speed is 38-40 degrees, the game is 44-46 degrees, and the toaster is 52-54 degrees.
Most dissatisfied
Large size and heavy weight.
summary
Those who want to buy it have better see if their chassis can fit.If your chassis is placed vertically, be sure to find something to hold or hang the radiator.
The heat dissipation effect is very good. I used it to shadow the 9800GT black jack. The original turbine has a heat dissipation standby temperature of 55-60 degrees, and the island has soared to 98 degrees... With this standby temperature of 40 degrees, the recent hot standby temperature is 45 degrees, and the island is 58 degrees an hour.(I added the 12025 Blu ray fan of the OC3.) The rotating speed is about 800.
Most dissatisfied
Can't take care of the power supply. It's too heavy. The line is hanging.
9800GT original fan standby 50 ℃ room temperature 30 ℃ no air conditioning Refitting the Caribbean with F122 12CM fan, standby 40 degrees, fan speed around 1700 revolutions, high load test 55 degrees, F122 workmanship is good, noise is completely acceptable, speed regulation is supported The overall workmanship of this radiator can make the heat pipe huge for pure copper Abundant accessories support most video cards. The key is that the fan is easy to install. It is easy to clean the dust in the future. It is a good choice. The weight is moderate (Be sure to select the right length of screw rod for installation to check whether the cooling pipe contacts the core)
Most dissatisfied
The polishing process of the base and copper tube is probably a cost factor. I hope that it will be improved in the future. After careful observation and visual inspection, the objects are not very outstanding, that is, 100 yuan level items
summary
It's a good choice, but pay attention to whether the PCI position of the motherboard is enabled. In general, this problem does not exist. The motherboards now are integrated with sound cards and network cards Computers without special requirements can be configured for large chassis
Starting from Dalian, a 12CM fan is added, which has obvious heat dissipation effect.The standby temperature is about 10 degrees lower than the original 4830 fan. When the CPU is fully loaded, the temperature is maintained at about 44 degrees, and it is reduced by 20 degrees.
Most dissatisfied
The appearance is really huge. I sold the heat sink to install it on my graphics card, but it could not be installed on the motherboard when I took it home. It was so harmful that I adjusted the heat sink myself before installing it. In addition, the noise is smaller than my original fan, but the noise of the overclocking fan of three 12cm should not be ignored.
summary
Generally speaking, the radiator is OK, and the cooling effect is there.
The 9600GT tested 3Dmark 1440 * 900 16 times anti aliasing, extreme torture, everything was ticked 42 full load 52, room temperature 30 degrees~resolution is 52 degrees~this pressure value~it's not afraid in summer~4 tubes only used 2 tubes~a bit wasteful~how can I say it will not be replaced in the future~I didn't know that the 9600GT played Mission 6 for 104 degrees before, but I saw Master Lu... there was no screen~
Most dissatisfied
It's a little heavy~12CM overclocking 3 F-122 is installed, and there is no wind coming through~The graphics card is slightly sagging due to pressure~The main board is just covered
summary
Not bad. 4 copper tubes are powerful. It would be better if they were lighter~
1. Cooling is the king's way.Otherwise, why bother to replace the original fan?My original video card has a standby time of about 60. After replacement, the screen will be black after 40 full loads and 120 anyway. After replacement, it will be about 60-65 (tested in summer in Chongqing) 2. The silence is very good. There is no sound in the dead of night. It feels very good.However, the 12cm fan should be equipped by yourself. If the fan you choose is not good, it may not achieve the purpose of mute.Fan is not expensive anyway, I suggest you choose a better one.(There is still noise when it is fully loaded)
Most dissatisfied
It is too big and heavy.The quality of the graphics card board is poor. It is estimated that something should be used to fix it.At the beginning, my video card doubted whether it could resist, but it was OK!
summary
It is a very excellent product and worth recommending.
The heat dissipation performance is really good. I use a 3850 star drill 512M. The original standby is about 50, and the full load is 65.In the Caribbean, the overclock reaches 750MHz, the standby is 40, and the full load is 48. There are enough video memory fins attached to cover the power supply. The 12CM fan is used to lock the speed at 20%, and there is almost no sound.
Most dissatisfied
It's too heavy. It's a great test for the PCB of the graphics card. It's better to add a backplane or sidebar.After installing my 3850, the PCB was slightly deformed, showing a slight bow.
summary
High end video card users deserve to try out the excellent cost performance.
The original standby 50 is more than 85 when the May Day Fair of Fairy Sword is held. The effect is very significant when the Caribbean overclocking three black crystal F126 is installed, the standby 40 is around, and the opening of Fairy Sword Five is not more than 60
Most dissatisfied
I haven't found it for the time being. It's a little smelly when I just installed it
Strong heat dissipation, solid materials, four heat pipes (copper tubes) and all copper heat dissipation scales.My card is gts250. The original fan is 47 in standby and more than 70 in full load. After using the Caribbean 37, it is 57 in full load.
Most dissatisfied
It's really a little heavy. I feel a little heavy after installing it.The heat dissipation does not take into account the power supply. If the PCB of the graphics card is very long, overclocking is a test for power supply.
summary
Overall, I felt it was very good. The only regret is that the cooling area is too small.
