The 14cm fan rotates at 1600 rpm very strongly. The bottom 6 copper tubes extend to the upper radiator, which is equivalent to 12 tubes. The visual effect is like thisThe overclocking cooling performance is strong. The 4 core U exceeds 3.6g, and the temperature control is good, 36~55 degrees!The down blowing type can effectively dissipate heat around the Beiqiao motherboard!
Most dissatisfied
It's a 3-pin interface, but the interface cable is equipped with a speed control button. It's a bit loud when overclocking and full load. However, the reduced speed is still very quiet for common use
summary
Overall, the performance is not bad. The rotating speed can be adjusted. The 14cm fan turns 1600, which is very powerful. Of course, the price is "not bad"
The heat dissipation is strong. When I7 is pressurized to 1.36 and PC MARK runs, it is pressed to 56 degrees at 1250 rpm. Once, the fan cable was unplugged for about 10 minutes, but the U is not 60 degrees. Even passive heat dissipation is quite strong, let alone such a large fan
Most dissatisfied
Too large, difficult to install, no original 1366 fastener, too expensive
There are six pure copper tubes on both sides. Without saying, the heat dissipation capacity is very good.The fan is adjustable.I7.920 overclock 4.4G, the daytime temperature is 28 degrees, and the temperature is maintained at about 45 degrees.It's only 38 degrees at night.Very satisfied!
Most dissatisfied
The volume is huge, but it can be considerate according to the heat dissipation.It is possible to block the additional radiator space of the North South Bridge and cannot be installed.It is better to equip a large space chassis with several 12cm+fans for front and rear convection. The heat dissipation effect will be super good, only higher than water cooling.
