Comments on Limin AXP90-X47

14600k pressure is enough. Pay attention to the height of the chassis when changing the chassis

It is already on board. Replace the 3500X. Although it's not a big increase, I can't help the price of 5600 now. The graphics card is still 580 million years old. By the way, if you want to save the machine and if you want to use itx, it is recommended that you do it all at once. I changed the CPU and added two disks, which is very painful to disassemble.

The heat dissipation effect is very good, the air volume is also very large, the air volume is very large, the mute effect is good, the air volume is large

Authentic, easy to use. Press 12400, and the temperature of small oven is more than 60 degrees. That's enough

Good batch, the previous * * * pressure game League of Heroes can reach 80, and it will reach 65 in the case of Limin

Very good. I will buy it next time. I miss the peaceful life very much.

It's OK to buy things that benefit the people. Buy them. Ha ha

Very good, 47cm heat dissipation and benefit people is considered as top current, but it is a little top capacitance

The radiator downforce fan is very powerful, small and exquisite, but powerful!

It's good. It's about 30 degrees standby on the E3-1245V6, and about 50 degrees video transcoding (see the load is almost half load). My chassis is Yingguang MS04, and the left and right air holes are sealed to cool the hard disk. The fan speed is about 1800, and the fan is quiet. The support with three hole positions is provided with the fan, and the bottom plate is compatible with the three hole positions of metal.

The pure white fan is very beautiful, fine workmanship, responsible appearance, very convenient, like friends can start!

Limin's current quality control is really inexplicable. The fins of the radiator tower are uneven in some places, so I'm too lazy to return them. It is used in the overclocking three hummingbird 2 chassis. It is equipped with 5600g, and the room temperature is about 20 ℃. The original AMD radiator can press less than 80W. If you turn on the pbo2 baking fpu, it will overheat and reduce the frequency, The original fan of x47 can press about 95W (95 ℃). If B9W is replaced, the power is about 5 ℃ lower. Under the same conditions, it can press about 105W. There is a limit for ITX downward pressure. It is not easy to blow 120W on the open platform. The original fan makes a lot of noise when fully rotating, The B9W is better, but the thick fan has close inner and side panels, and the high-speed wind noise is obvious.

Very good. The baby is very tall and of good quality. It seems to give people a sense of sophistication, and the price is also appropriate. This online shopping was very pleasant, and I praised it????

The radiator is very good, recommended by others, but the fan doesn't feel very quiet

I have bought countless Limin radiators, Limin 53mm down pressure radiator for nas, The 140 heat sink used by the x99 server has very good floor details. Plastic tape is used to insulate the positions where it contacts the main board. This is a good comment.

Bangbang Bangbang, I must praise that the after-sales service is absolutely invincible. I accidentally broke a snap wire, told the customer and sent me a replacement one. Come back to your house to get 240 water in summer.

The heat dissipation capacity of mini small host is very good 47 ㎜ high. Four copper tube heat sink is absolutely one of the best. There is a little noise when the fan runs at full speed

This heat sink is really good. There are not many heat sinks available at this height. This is a very good heat sink. Most mainstream processors can use it, and the heat can be suppressed. This is a very good product.

Easy to install, silent, much quieter than the original fan, CPU temperature has also dropped a lot

The workmanship is fine, the air volume is sufficient, and the sound is very low. It's classic and beautiful.