The 5800x has not reached 70 degrees, and the effect is very good.But there are also fatal shortcomings. The noise is too loud!50% speed starts to increase significantly until the plane takes off, deafening!It's no exaggeration at all.In addition, I feel that there is something wrong with my pump head. I don't know whether it is the sound of water flow or the sound of pump. It is louder than the sound of low speed fan. You can obviously hear the hissing sound when you are standing by.I got a set of Tt chassis, power supply and water-cooling. To be honest, I think it's very ordinary. It's a warranty and niche!Reasonably, I regret it.
Large fan, large air volume, large silence, almost no sound when starting up, no light pollution, which is suitable for people like me who don't like rgb light pollution,
The quiet air volume is relatively large, with temperature and speed display. The last time I used tt for the second time, it was six years old and it broke down.
Very good, sensitive muscles can also be used, very good, sensitive muscles can also be used, very good, sensitive muscles can also be used, very good, sensitive muscles can also be used
There are many advantages. It is easy to press 10990x. The daily pressure is 30 degrees, and the pressure test does not exceed 65 degrees.However, there are two disadvantages: slight water flow noise, and the cold head LED display screen will not always keep the captain's shield logo, and it will become the tt logo after more than ten seconds, and there is no software control, so it is angry.
The wind is strong and the noise is very low. The temperature of the whole chassis can be controlled at about 30 degrees when it is normally below 1000 rpm
It is matched with the H6 chassis of Iron Man, but because the front panel has LED light strips, there is no need to bring a waiting fan, so it is a waste of money
I wanted to return it, but it was really a toss up. I really can't understand why your water-cooling system is not cheap. Why don't you check it when you ship it.
The appearance feels a bit long... it doesn't look like second-hand after careful inspection.Maybe it's the material problem. As a chassis fan, it can hardly hear any sound when rotating at 1300 rpm. Very good mute performance. I felt it with my hands, and the air volume is also very large. I hope I can use it more years.
Let's not mention the water cooling. It's inconvenient to paint the silicone grease on the surface without any help. There is a film on the surface that can be torn off and stuck on the surface. The products made by such a large company are really not very good. There is also a fan that makes abnormal noise when rotating fast. The vibration sound of Katz stuck in the fan. I thought that the line had reached the fan and found a circle. Alas
The product is very high. In fact, the noise is not very loud. The wind is really strong. You must follow the guidance. The installation direction must be correct. After installation, you must enter the BIOS to set the speed. I set the full speed when I start up. The lever is 2000~
Yes, the noise is very low. It is used to hang on the CPU radiator as a cooling fan. It is controlled by the mainboard QFAN. The minimum speed is very low, so the lowest temperature gear is turned to 60% of the speed, about a thousand dozens of revolutions. The noise is very low, almost inaudible. I tried it at the highest speed, about 2000 more.The light is soft and the transition is smooth, and the other head is connected to the chassis controller and the divine light synchronization is normal.The price is slightly high, five points high, and the packing box is relatively simple.
