The A520 meets the basic needs of the 5600. If you have higher requirements for the interface, you can choose to replace the B550 of Onda or other brands. If you are lucky, you may be able to buy a cheaper one.
The motherboard used to install ITX is very good, with high cost performance. Other ITX motherboards are too expensive. The CPU uses a new 5600G, with good performance. The motherboard has complete functions, is easy to install, has an average appearance, and the bios is easy to use, very good
The price of the CPU package is quite good and cost-effective.The design is also reasonable.Products that are well balanced in all aspects must be praised.I don't need to say more parameters, so I will understand if I understand.Of course, it would be better if you could give another pciex1 (now you can add extension with the second 2280 of m.2 2230)
The small board of the amd platform is not bad. The 5600x and 6700xt boards are functional. The board is very well made. I just need to complain about the wireless network card and replace the ax200 myself
There are many hardware functions, but the driver and bios are still poorly optimized. At present, the new 5000g series does not even have video memory settings. I hope to optimize them as soon as possible
The r5 3400g is not supported, and the broken motherboard is not noted on the home page. It is also not so unreasonable that the physical store is not returned or replaced in Kaifeng!!!!!
Packaging protection: the packaging is very powerful. An air bag is placed in a large box to shock the installation. Difficulty: there is no compatibility performance for the installation problem of the industry personnel. The 4650g that does not support the 21 generation Apu of the Ruilong is lit up at one time. After installation and debugging, it is compatible. Appearance: the same version and interface design as the 550. The heat sink SATA interface pcie slot is different from other features: The built-in debug light is very good, which can avoid many problems and help you troubleshoot two 12v4 pin rgbs at the fault point.I wonder if the two 5v3 pin argb interfaces are the first to be evaluated
One place is easy to slip, the screw quality is not very good, the heat dissipation is not good, other things are OK....I hope a video explanation will be released next time.....It's really a bit of a headache. It's slippery and the solid can't dissipate heat. It can only be placed in the next place
I bought this motherboard because it has two front USB3.0 plugs, can also plug in two m2 solid state, and has reserved wireless WIFI positions. The VGA interface can also use the old monitor, and the P3.4 BIOS can also support low-end entry-level Speed Dragon 3000g processors.
Although this board is A520, it has all the necessary parts. It has three M2 ports, and has added an M2 wireless network card. It can also add a hard disk in the future. It is not planned to display it alone for the time being, nor has it installed 2.5 inch and 3.5 inch hard disks. The small chassis is still empty after installation, so enough space can be left for the radiator.