Limin TL-C12C X3 black 12cm fan set, starting from Taobao 50+, with a three-year warranty.Limin entry-level performance fan, which can't be played at this price without it, and argb version (add about 15 yuan) with ASUS AURA is a good choice for friends who like lights.
Finally, I replaced those cheap fans, and they clicked when I started!It is indeed beneficial to the people, a big brand, strong wind, almost zero noise, no light pollution, suitable for the elderly!?
The same sentence is beneficial to people yyds I bought a fan installed at the back of the chassis as a fan for going out Later, I heard that when the heat dissipation after the inlet air pressure fan and outlet air volume fan is not enough, I bought a c12Pro b12 to try Air volume and wind force: the air volume is ok Mute effect: the noise is within the acceptable range Appearance: black should be bought
Heat dissipation effect: not bad, reduced by 4 degrees. Air volume and wind force: It is very big, whirring, and the fan blades are strong. Mute effect: very good, silent in standby, acceptable with full load. Convenient installation: if you can use glue nails, they are really better than screws. They are screw free and shock absorption. Appearance: very good. The gray one is simple and durable. Product packaging: newly produced last month, intact.
The fan installed on the top of the cabinet should use this kind of reverse air outlet, otherwise the whole fan blade and shaft body are suspended in the air, and it is easy to make abnormal noise after a period of time
The quality of the fan is very good. Last year, I bought four fans and used them. Now there is no problem. Low wind speed makes little noise. High wind speed has strong heat dissipation. The top of the chassis is always poor. One fan with air outlet has been decisively added this year
Although I won't install with glue nails, the noise is very low after installing with screws.The most surprising thing was that after the fan was installed at the rear to draw air, when the Xeon e5 2667 v2 under my poor two copper tube CPU fan was fully loaded, the CPU temperature was more than 40 degrees, nearly 20 degrees lower than before.The Navidia graphics card T600 without fan under high load is also lower than 50 ℃.From now on, you don't need to open the case and blow with the air circulation fan. You can close the cover and use it at ease. It's the first time to use a 6-year warranty fan. It's really a good product.
The installation process is very anti human. Two installation methods are provided, one is silicone nail, the other is ordinary screw. The silicone nail is soft, and this fan has two holes.There is a snap on the silicone nail, so it is impossible to press the snap into the hole of the fan by hand. You can only pierce one hole first, and then pull hard.After pulling, a long piece of silica gel hangs between the two screw holes of the fan, which is difficult to pass through the second hole.I don't even mention installing it on the chassis.It's very difficult to hold it in hand and wear it naked. The second kind of ordinary screw is inserted into the fan hole, and the screw is fully screwed in. Only half of the screw can be inserted, and half of the screw is left outside.It was installed on the chassis and shook.No more words. Don't buy a fan that is very bad!
Limin's fan is really easy to use. The mute effect is very good. There is no sound at all. The price is worth it. I recommend you to buy it. It is the first choice for civilian installation. I have no demand for rgb, and it's just as dull
If it is installed upside down, it is better to use this reverse fan. If the ordinary fan is installed upside down for a long time, the rotor will always be pulled out due to the relationship between gravity and wind pressure, and the bearing cannot work at the optimal position, which will affect the service life
The wind seeker PK620 can install 7 14CM fans, 3 12CM fans, 10 fans in total.I bought this one without lights. It's not fancy. It's just a cooling air duct.I bought a reverse fan at the bottom 12cm. It looks natural. It should cost about 10 yuan
The heat dissipation effect is very good, and the installation process is very simple. It can also be placed on the chassis heat dissipation and CPU fan. It was originally a single fan, but now it is a double fan. The temperature is four or five degrees lower than the original temperature, the wind is strong, and the sound is very low. When the side cover of the chassis is closed, the sound can hardly be heard.
Things are always good, and the quality of workmanship is first-class. When the temperature of the air duct is set, there are a lot of standby machines, which remain around 30. It is too hard to get them and complete the assembly. When I bought them, I didn't notice that the controller of my chassis is a 3PIN, so I had to buy several 4PIN to 3PIN adapter lines. So if you want to buy a chassis with a controller, please pay attention to the interface,Don't cook like me (dizzy)
Heat dissipation effect: the CPU has not been operated under high load, so it cannot be seen Air volume and wind force: very good Mute effect: very quiet at low speed, very loud at the highest speed, and can be heard three meters away at night Convenient installation: once the chassis is opened, the screws can be screwed and plugged Appearance: I don't like light pollution. This low-key and simple one is good