The heat sink on the newly bought Mingxuan B560 motherboard is too high and too large to install the existing Great Wall radiator. There is no way but to buy this again. It's OK. I5-11500 is normally used between 25 ℃ and 30 ℃, and the full load can be controlled below 58 ℃ (room temperature 16 ℃), which is quite good.
It's easy to use. The most important thing is that you can disassemble the rotation direction by yourself. It can't be disassembled here. Just disassemble it and rotate it
It is used for the i3 12100 of ITX. It is 35 degrees at ordinary times and 38 degrees in a single exam for 10 minutes. I am very satisfied. Unfortunately, it is similar to my USB 3The position of 0 wire is a little conflicting. It will be perfect if it is 1cm smaller!
Beautiful appearance, reasonable design, very exquisite.The aluminum radiator is very thick, with five heat pipes.The height is also appropriate. General small cases can be put down without collision, and there is a certain space without wind tunnel.The installation is also very convenient. Determine the direction and tighten a few screws.The fan is installed in the cool fish g5plus chassis, which is very suitable. It can hold about 3600 CPUs. At present, I have 3600. The temperature is about 30-50 degrees for daily use. Playing games will be higher. The itx chassis is great
The style is very generous, the quality is very good, the price is reasonable, and the cost performance is very high?,You can buy it with confidence?,Very exquisite workmanship?,Worth buying?!
After a lot of hard work, the computer finally turned on... My friend gave a boss a piece of paper with a Speedo 760K and bought a small case at random. It was beautiful to think about it. Just watch a movie in the living room. Who knew that this htpc was so laborious. The height of this radiator was low enough. Who knew that there was no * * * fastener... I also bought two fasteners for the old motherboard, and the heat dissipation was OK
Before, the CPU fan of the host was not good enough, and it often crashed.There is not much space in the chassis, and fans with more efficient heat dissipation and small space occupation are required.This one is convenient for installation and space saving.The problem was solved. There was no problem inserting many devices.
It has been installed into the machine. I changed the fan to Limin's reverse air outlet, and changed the downward pressure to the upward exhaust.The E3V3 with a pressure of more than 100 watts is barely strong.[Advantages] 1. The evasive memory design is well received, and my ultra-high vest strip is completely unstoppable;2. It is convenient to change the fan. The original fan is thin, and the package contains 12025 fan screws [Disadvantages!] 1. Workmanship needs to be improved. The contact surface of the heat pipe is not parallel to the fan;2. The fastener has no back plate
At first, I was a little worried about whether it would block other things. When I installed it, I found that fear was unnecessary, and I could find the right direction to avoid blocking.It is just placed in the ITX case.It is very quiet. There is almost no sound in standby.
I bought this for the nuclear display small mainframe. Personally, I think it is OK to press the amd5600g. The air duct of the computer case is also good. Two chassis fans are added for air inlet and outlet. This is OK
It seems that the quality is good. After reading the instructions, I don't know whether the 1151 motherboard is easy to use or not. I don't want to install it now. It has been almost a year and a half since I wanted to assemble a new computer, mainly because the original computer has been fixed again.
Not bad. I found several downward blowing radiators, which can withstand my magic U, but for some reasons I changed to upward blowing. Master Lu's pressure test is great if it does not exceed 90 degrees.Please ignore my temporary memory module, hahaha
