Comments on Buffalo T7

Any air cooling can press

The radiator is very good. It is used to press the i5 11400. The actual effect is very good. It can be pressed. Recommended to buy. The silicone grease sent is also very powerful, and there are a lot of fasteners. It's really easy to use!!

The price is cheap, the light is not very bright, and the effect is average. The bracket for fixing the fan is plastic, which is a little cheap. However, the hook is still stable. It is just suitable, but generally OK.

Getting a motherboard from a friend is a treasure. I have a hard disk that I don't use at home. I bought a Buffalo fan in the mall and it went very smoothly. The system is installed, and after trial operation, it is very stable. Recommended! It adds color to my computer.

I bought it many times. This time, I changed the heat dissipation for my relatives' old platform. The original starting temperature was 70 degrees, but it immediately dropped to more than 40 degrees. Of course, the wind speed and noise are the same, but I don't care about the old platform under the table

Not bad, really good, double fan cooling is good, worth promoting, the price is also very cheap

I bought one in January and used it for less than a month. The fan makes a loud noise. I replaced it. After using it for a period of time, it also makes strange noises from time to time. I don't have to bother anymore. I'll just use it. I'll change it to another brand next time.

It is very convenient to install by yourself according to the video. It looks cool when there is light.

I have bought similar products before, and the effect is average. This brand is the first time to try, and the effect is unexpectedly good. The noise is low, and the heat dissipation effect is very good. Installation is also simple, overall satisfactory.

The overall product is fairly good. I reduced the LED light myself, and now it is used to suppress the 3600 without overclocking. The temperature is stable at about 44. However, the noise is not small. Although the software is not accurate, there is still 40 decibels, and the fan sent is still in reverse direction (it feels like someone else has used it). However, the price is not too much. The disadvantage is that the speed cannot be controlled+the noise is too loud. Everything else was OK.

I bought it several times

Good products, excellent service, excellent cost performance, worth recommending to everyone

My computer has been running for nearly 10 years. The original CPU fan is getting louder and louder, and the heat dissipation is not particularly good. I chose this big buffalo fan, which is beautiful, easy to install, and has a good cooling effect!

It's very convenient to install the lamp. It's also good value for money
Mainly replace the original fan for 9100F
Although the installation on the ITX motherboard is a bit nervous, there is no conflict
It is estimated that this will be used on low-power CPUs in the future

For the inter platform, the buckle is not easy to use and cannot be stuck. The motherboard was removed, and the screws were installed reversely and stuck.

No blowing, no blackening. After replacing, the temperature drops steadily to 40 to 50 degrees. The key is that there is no sound at all, as if the chassis is not powered. Good thing.

The installation is relatively simple. It doesn't make much noise when running. The cooling effect is fairly good

Very good, the machine is very beautiful. Value for money. Come again if necessary!

Constant speed, so I can't hear the ups and downs of the original!

The heat dissipation effect is average. The heat sink is very light, the contact area is not enough, and it does not fully contact the entire processor plane, with 10% exposed.