I have always been committed to loving the brand of overclock 3. Starry Donghai Warcraft bought it for the second time. I'm afraid that I will stop production in the future and collect one more radiator. I really like it Heat dissipation effect: very strong, stronger than most radiators Air volume and wind force: the wind force is relatively large, the wind pressure is greater, and the noise is slightly higher when the vehicle is fully loaded Mute effect: very good at low rpm Easy installation: OK Appearance: This is the most handsome one. It's the most beautiful star radiator Product packaging: more handsome, but I don't know how to adjust the red and blue color contrast lights on the packaging
The best way to use this kind of heat sink is to install it before the motherboard is installed in the chassis. Otherwise, you will know how anti human it is!
Mute effect: good mute effect, very quiet Appearance: fine appearance, heavy components, manual control of multiple RGB changes Heat dissipation effect: stable heat dissipation
Although I have sold the radiator of the overclock III for more than ten years, and I have a deep understanding of the quality of the overclock III, I can't help complaining about the texture of the main product, which is still average. Although the cost performance ratio is good and the fan is good, I still complain about the texture of the metal parts, which is always not smooth enough.
The quality of the product is very good. It is suitable for small overclocking or non overclocking. It's just a little troublesome to install it with full materials
It can hold 6950x of 4.2, but not 4.3.In addition, this thing has a sharp head with an elevation of 155, but you should prepare the chassis according to the actual height of 157.
Mute effect: very quiet, almost no noise Heat dissipation effect: the room temperature is less than 15 degrees, the streaking pressure is 10600kf, and the startup temperature is 25 degrees The silicone grease sent is very hard and not sticky. What's more, the rubber band for fixing the fan will not be worn out for a long time and then break
The metal contact surface with the CPU is a bit large, half of it is empty, the fan installation is not very convenient, the left fan is close to the chassis, the space is small, one corner can't be fastened, the silicone grease sent is too dry, it can't be wiped on, attention should be paid to the details