Connect the line from the LAN port of router 1 to the LAN port of router 2. Router 2 is equivalent to a switch.However, it is better to turn off the DHCP function of Router 2, and note that the LAN IP address of Router 2 should not be the same as the IP address of the computer
Connect your company's network cable to the router's LAN port, and turn off your router's DHCP server (use the router as a switch). At this time, your computer's link route should specify an IP address.That's the same network.
1. The router address can be any of the above network segments. You can also set up a single network segment and VLAN, that is, remember to do the relevant VLAN and configuration in the core, and then put the core and routing interconnection interface on the corresponding VLAN. 2. The three network segments should be connected to routers (I think it is a wireless router). The interface of the next router should be configured with the corresponding VLAN IP, and the gateway should be set as the VLAN interface of the core switch (if the gateway is on the core). Then the static route of the core switch points to the public network router. The router should also remember to point the returned route to the core VLAN interface.If the next router is a wireless router, remember to change the WAN port to automatically obtain the address, set the DHCP function, and turn on * Line Function *.
You can plug the LAN cable into the WAN port of the wireless route. Although the IP allocated by the wireless route is different from that of the LAN, it is interconnected.If you want the same.Turn off the dhcp of the wireless routing, and plug the network cable into the routing LAN. The IP segment is the same
The simplest small plastic box broadband routing can be realized
Example: There are two network segments 1 and 2. If segment 2 needs to access the address of segment 1, then [192.168.1.0] -- (WAN port 192.168.1. x/255.255.255.0) Broadband router (LAN port 192.168.2. x/255.255.255.0) -- [192.168.2.0]
The WAN port of the broadband router is set to a certain address in section 1, the LAN port is set to a certain address in section 2, and the computer gateway in section 2 is set to the LAN port address of the broadband router.If there is another gateway in Segment 2, just add another gateway to the computer in Segment 2.
If a traditional router is used, the static routing configuration of this network segment conversion is the simplest. You can find it in this CCNA document.
First, set the LAN port of your router to a different network segment from that of your company's router. For example, your company's router is 192.168.1. x,For example, if the company router is 192.168.1. x, you can set the wan port of your router to 192.168.1. xx, and set the gateway to the address of the company router. The mask is the same as that of the company router.
