The router prompts that the connection has been in progress. The reason for the failure is that Fault 1: The circuit is not connected correctly.The connection method of this router is that the network cable or the network cable from the ADSL cat should be connected to the WAN port of the router.The network cable from the computer should be connected to the LAN port of the router. Fault 2: Wrong choice of Internet access mode or wrong input of broadband account and password.This needs to be verified with the operator.
1. Check the local connection status of your computer, and whether the IP address is automatically assigned or manually assigned by dhcp. If the router enables the dhcp function, do not manually assign an address here to avoid network segment differences or IP address conflicts. 2. Make sure that the MAC address filtering function is not enabled in the router to prevent computers not in the list from connecting to the router. 3. Check whether the network cable and crystal head are in good condition, or try to remove the network problem by changing a network cable. 4. Try changing the LAN port of the router to make sure that other computers can access the Internet normally through the router, and eliminate the router problem. 5. Restart the router, computer or other network devices. 6. Whether the computer can automatically obtain the address assigned by the router. If it is not possible to determine that the router has the dhcp function enabled, if the router has the dhcp function disabled, manually specify the address, mask, gateway and dns address of the network card. The network card tcp/ip address specifies an address between 100-255, which is the same as the first three digits of the address of other computers, and different from the last segment. 7. If it is dial-up broadband, it is necessary to determine whether the router dials or the computer dials. If it is a router dial-up computer, it is only necessary to connect locally. Do not dial again. If it is a computer dial-up, check whether the broadband dial-up account and password are correct.
Look at the hole on the router, find a toothpick or something, insert it, and let the router return to the factory state. Wait about 10 seconds, then turn off the power, turn on the power, connect to the computer, and reset the router's IP address.
