In the unit setting option in CAD software, you can adjust the displayed coordinate precision through the command line.The specific operation method is as follows: After entering the company setting interface, enter "units" (excluding quotation marks) in the command line to display the current company settings.Users can fine tune as needed to achieve higher accuracy.This function is very important in the CAD design process, because it allows designers to accurately measure and dimension, and ensure that the final product meets the expected requirements.
The last digit after the decimal point is the rounded approximate number, which differs greatly in accuracy. Four or three digits are determined by the accuracy requirements.
Those who have answered you are those who do not know the general plan. If you do as they say, you will be miserable! The coordinates in the general drawing are marked in m, while your drawing is drawn in mm, so conversion is required when marking coordinates. Divide the measured value in the drawing by 1000 to achieve the unit of m.In addition, the phase difference between the coordinates of the general drawing and the drawing coordinates is 90 °, that is, the actual X coordinate is in the X direction of the drawing, and the Y coordinate is in the X direction of the drawing.There is no problem with this picture. If you change it, you will not only paint the lily, but also dig out the snake's eyes.
